Rain Bird SWGE075 EZ Pipe/Swing Pipe Elbow Fitting, 3/4" Male Pipe Thread x 1/2" Barb, 10-Pack

So, lots of rain bird sprinklers have 3/4" female npt threads @their bottoms. These EZ Pipe, swing pipe elbows have Mnpt, but retain 1/2" barbs to connect with the pipes, then allow you to use (reliably available) risers, with Female threads Connector, X 4" riser W/ the ability to cut it off at any length you need: sets of threads in Mnpt, are separated at 1" increments, to allow for drift-in dirt/sand and easily customize the increase in height! Easy-Peasy, and cheaper than other alternatives!

Used to replace a broken fitting. Lubricated with some dish soap and it slid into the pipe and threaded into sprinkler head. No leaks. I'm satisfied.

You going to need this if you have a irrigation system

Fittings were of high quality and packaged well.

They are very professional and courteous. Very fast shipping. Highly recommend them⭐️⭐️⭐️⭐️⭐️

I called Amazon and they are sending me a new order, but I am convinced it will be another single elbow. The specification says pack of 10 but it is way down at the bottom of the specs and you have to click see more to even know it is a pack of 10. See below:About this itemElbow fitting for use with Rain Bird's EZ Pipe systemUse with 1/2" swing pipe to create adjustable fittingsEasy twist-in barb insertionWater-tight seal, no glue or clamps neededHelps absorb shock from mowers and other traffic.3/4" male pipe thread (MNPT) x 1/2" barbSprinkler systemPrimarily used for residential installationMale pipe thread and spiral barbed elbowAllow for easy connection of E-A pipe to PVCMeasures 3/4-inch; pack of 10Show less

They are NPS or MPS or MNPS- male national pipe thread straight (not tapered). Other than that, they are fine

Might need to use Teflon tape if there’s a drip.