dephen 5V USB LED Light Strip 4.9ft, 480LEDs Daylight Dotless COB String, Flexible and Cuttable Rope Lighting, CRI 90, Self Adhesive Tape for TV Backlight, Bedroom, Cabinet, Mirror, DIY

Added a couple of rows of lights to the bottom of my monitor to light up my desk with this. Nice, soft light. Bright enough. Powers up to the previous setting. I don't need to use the inline controller much, just set it and forget it. The adhesive made it easy to install and even with a 180º turn to make two rows it keeps sticking nicely.

Short cut markers, adhesive is strong.The .49 inch cut lines keeps you from wasting LEDs. It was easy to install in this movie theme lightbox. The LEDs are cool white and very bright.

Exactly what I needed. I can easily plug or unplug it from the USB port on my 3d printer to get a better view.Good adhesive, easy to cut to size, and very bright.Its also a nice bright white without too much blue light. I've had a problem in the past with cheap led lights having a blue tint when they are advertised as daylight or white.Also good to note that all the pictures were taken with no other light sources in the room turned on.

Nice accent light. Changed to a 3000k color, and that plus a change away from the std LEDs made for a softer lighting effect. I used two strings of lights coupled to a two outlet 5v usb charger. A 12 or 24 v setup would have been brighter but also bulkier than my wife liked. This worked well for our purposes.

I wanted some lights for my mantle in my living room and these were perfect. Super easy to install and the light is easy to adjust.

Used for lighting 3D print project Dr Who TARDIS windows and top sign backlighting.A) they measure and work as advertised. Measures about 1.8mm height.B) love the . 49" cut spacing vs others at 1.5"C) soldering leads to pads after cutting was easy with a little practice.D) tried resistor and buck converter to lower brightness to reduce heat at lights. Worked great.E) strip length was right, BUT both units I got had been soldered in multiple places, as if from scrap strips. Joints soldered WELL, but I don't like the adhesive backing being the only thing holding segments together in many places. I think other sellers will have same thing though.F) adhesive backing holds VERY well. I had to remove a strip from model. It readhered well enough that I was surprised.G) if you will be enclosing them there by trapping the heat, definitely use reduced voltage. 3v still plenty enough bright, but no significant heat buildup. All the other comparable brands with similar specs to this COB strip have the same power consumption at rated voltage.After using 2, I ordered the Pautix 2m strip in a warmer 3000k light. An extra . 5m for a dollar more.No hesitation recommending these to a DIYer

Use these in light boxes 3d printed. They work well and can be trimmed to size. I use cheep phone charger for power and the run 24 7 will no worries about over heating the power supply or lights.

Have a nice sunny white to them, and look good. However, when I was peeling them off the paper, the glue stuck to the paper and not the strip, so I had to put the strip on with blue tac. Definitely not ideal.