Full Overlay Blum 110 deg Soft-Close BLUMotion Clip Top Frameless Hinges, Pair by Blum

I was in the mode of replacing all my hinges (24 yrs old set of Blums (70.259)). A few were failing and wanted the soft close. I bought a set of the Berta and a set of the Blum to compare before buying 20 sets. Berta is not bad but the Blum set is visibly and functionally made better. I now understand why the Blums cost more. For me... keeping with Blum made it easy to replace and install was so easyFit was a perfect match! Very happy with the product. You do get what you pay for in this case.Note: there are no instructions. But if you're replacing existing hinges you shouldn't need it.

Wonderful replacement for IKEA Besta hinges! I purchased Besta shelves online but forgot to add the hinges. If I didn’t find these I would have to wait until end of July for IKEA to deliver the hinges because of the quarantine delay. These saved me tons of time :) no instructions included and I couldn’t find any online, but I figured it out. It’s pretty intuitive. They are also soft-close, which works without issues as well. All in all, so glad I found this listing!

One of the two hinges on a cabinet door got disconnected which became a safety concern. Discovered how easy it was to remove the door and learned that the hinge was a Blum full overlay. I couldn't find the exact model that I had so gave this one a try and it ended up being a perfect fit! All I had to do was remove two existing screws and reuse those to install the new latch. I didn't even need to remove the original mount. Props to Blum for a backwards compatible design!

I was pleasantly surprised on the uality of the hinges and ease of installation.

Would be great to have some information about the setback for the hinge pocket and the placement of the hinge plate. I searched the Blum website and could not find anything. They have an Excel spreadsheet calculator but I couldn't get it to work. Finally found some vague references that seem to have done the trick. Don't know why they can't just provide the numbers with the parts or provide a table on the website.

Just exactly like you think it's going to work, these adjustable hinges work great and soft-close is a nice bonus. You need a 1-3/8" forstner drill bit, of course, to drill the hole in your cabinet door. The cabinet door must be at least 3/4" thick, otherwise your forstner bit could poke out the front of your door! It's also very helpful to have self-centering drill bit to pre-drill screw holes in the exact center of the holes in the hardware. I did the whole install with hand-held cordless drill and had perfect results.

This is, or should be, the gold standard of soft close hinges. They are sturdy and well built.Pros - you can adjust these hinges in/out, up/down, and side to side without removing them; you can turn the soft close on or off, this feature is great for adjusting the closure rate on cabinets with multiple hinges.Cons - they do not come with any instructions on how to install or adjust the hinge.

Using a Kreg template installed these hinges in minutes on two doors of a record cabinet. Easy to assembly! I had to adjust one door up about two mm, no problem. The other door needed the bottom pulled back about 2 mm. Again no problem. The soft close feature works well (I turned the top hinge "off" for faster closing). I will definitely buy these hinges again (I already have a request for another record cabinet).