Minwax 356150000 One Coat Polyurethane Protective Wood Finish, Clear Semi-Gloss, Quart

I built a new bookcase out of pine planks and a finished plywood back. After one coat of Danish oil, I put on two coats of the Minwax One Coat. It went on very smoothly and with a little caution no runs at all. I could have probably gotten away with one coat but two coats seemed to give it a little deeper finish look. Clean up was super easy and I’ll get a lot more use out of my brush. I am pleased with the results and product. I’m glad not to have to put on 10 coats of Danish oil. For this project it was perfect.

Super impressed, one coat, looks great. Goes on milky of white, but dries crystal clear. Dries fast…. Or faster than urethane anyway.

Applied to factory sanded face grade “A” plywood after vacuuming and wiping down with a damp cloth.I noticed that going against the grain the cloth drug a bit on fibers not visible. Coat one was dry to the touch in less than 2 hours but had a slightly bumpy surface. Next day I hand sanded lightly with 240 grit,vacuumed and damp clothed the surface. After inspecting for any remaining rough spots the last coat wasApplied with a smooth gloss result. I will use this product again.

Good finish and one coat seems to be all you need. The value was really good compared to big box stores. Goes on well smooth texture time will tell on the strength of the coating. Negative is if you get it to thick it turns white.

As you can see in this picture, I used that to finish my vintage cabinet. Applied over chalk paint, using a roller and paint brush. Soft touch, no glare.

Simple, it worked. coverage came out well.

Really worked well and only had to apply one coat.

Streaked, very thick . Dried as fast as I put it on and was very noticeable . Did not dry smooth