Description
- 1.External cleaning:Gently wipe with a soft cotton cloth, especially the mouthpiece part of the mouthpiece, because it will often be held by the mouth, we must pay attention to health, it is recommended to use boiling water before using it, and then use a paper towel to remove water droplets or spin dry Can.
- 2.Internal cleaning:if it is a core-type cigarette holder internal cleaning is very simple, because it is used by the filter in the filter, the mouthpiece wall is only a small amount of tar may leak due to the installation is not tight, just use a tissue or cloth slightly wipe clean Can.
- 3.Internal cleaning: The cleaning of cigarette holders is mainly aimed at cleaning cigarette holders, because this type of cigarette holder can be used repeatedly for cleaning, and the cleaning links have a crucial role in the use and filtration effects:
- Users are advised to do a simple swabbing after using a half pack of cigarettes. Generally, they need to be cleaned when they feel that smoking is tight during use. Pull out when cleaning, and pay special attention to any style of cigarette holder when pulled out in a spiral way to pull out, a great impact on the protection of the cigarette holder seal; pull out after the section to wipe clean, on the filter Small hole with a needle cleaning;
- If it has not been cleaned for a long time, the tar in the residual cigarette holder is not easy to clean, and it is soaked in warm water of about 50 after being pulled out. After about ten minutes of soaking, it can be swabbed, or it can be soaked with a few detergents. The cleaning method must be used after the water is dried naturally, otherwise the smell of smoke oil will affect the mood.
Specification: Color: Bronze Material: resin + metal Product size: 13*8*6cm Packing size: 17*12*6cm Weight (with packing): 95g Packing includes: 1 * Hookah Smoking Pipe, rubber sealing rings cleaning method: Generally pumping more than 10 cigarettes must be cleaned once 1, out of the filter head (built-in filter to use the configuration of a key to turn out). The exposed filter head is turned directly by hand. 2. Pull out the inner tube inside the filter head to see a lot of black tar. 3. wipe with a paper towel, or rinse with water, or use alcohol to clean; wipe dry. 4. Check whether the two small holes in the inner tube are unblocked; if there is a blockage caused by tar and other substances, use a toothpick or a small needle to insert it into the clear. (Note that if the hole is clogged, it is very difficult to smoke) 5. put away the inner tube, cleaning is completed; installed, continue to use. Note: If you do not clean after pumping for a long time, it is easy to make the tar inside the block (performance: smoking is very difficult or inability to smoke), increase the difficulty of cleaning (often after a simple cleaning is not so smooth), In that case, it is best to dip with alcohol, first press the above steps 1, 2 and then turn the back cover down. Put in alcohol for a while. Use a toothpick or a thin metal wire to clear the inner tube and small holes (especially two or four small holes) and rinse it.