Stanbroil Low Pressure Propane Gas Flame Failure Safety Control Valve Kit Fits for Fireplace, Fire Pit, Heater

Worked great on my firepit easy to install

Bought a set of outdoor furniture off Marketplace that included a nice fire pit. The valve on the pit was frozen. I purchased this one as a replacement and it works perfectly. I would purchase this again.

Worked perfectly for our application. Easy to install. Great replacement.

Great quality.

Product work good could definitely tell that it was a little bit more heavy duty than the original

Worked fine Easy to install Heads up: mounting thread is narrow so it will mount easily to thin material only. I tried to mount through 1/4" thick fire table base and the width of the threads were too narrow. I had to modify.

Return not enough hook ups for my application!

The original one broke on my firepit. Replaced it with this one. Factory Mounting hole was slightly smaller than this threaded shaft. But drilled out hole a little fit good. Works perfectly.

We have a natural gas fireplace on our deck and the control was not working to hold the flame on. The fireplace was only about 6 years old, but the control was getting sloppy and unreliable, and I was concerned about any potential gas leakage. I researched replacements extensively and this unit seemed to be a very good direct replacement. I matched the old units stampings etc to this one. I had to do some fiddling to retrofit this unit (not because of the unit but because of hole spacing etc from the old control and the firepit), and it is working very well. I highly recommend it. Check your specific application needs/connector sizes/pressures etc, and be sure to test once installed for any leaks with your installation work. Have it professionally installed by a certified gas fitter if you have any concerns.

Used this on a fire table. Used as a replacement for original anf it worked great.

Not exactly as displayed