Router Sled - Wood Slab Flattening Mill Router Jig - 12mm Up to 1000x600mm (600x600mm), GG-RS12-SLED

After starting to assemble the router sled ready for the weekend I noticed the holes to screw the clamps to the top rails didn't line up. The roller holes are 26mm and the clamp holes are 33mm. Not only that the screws are too long so can't tighten the screws. Wish I payed a bit more money for better qualit! Lesson learned.

Once assembled and made square the unit works perfectly well, and the router slides easily along the rails. It would have been 5 stars except that it really needs a second set of clamp (or the set that arrives with it to be able to use both holes) to prevent any "wobble". These are easily bought from Amazon (12mm) and are easily fitted, so no big deal. Overall excellent value for money (even including the extra clamps).

Good quality bearings and rails . You will need a large router with plenty of depth of cut as the mounting plate is quite thick.

The instructions are diabolical. The router tray is not big enough to fir a small router on it with out taking one screw out of each support. The ecross bars are to thick for the end brackets. The end brackets have 2 holes for attaching each one, but only one of the two holes lines up at the same time. So even if you could get the bars fitted the slide would go up and down at an angle and not parrallel The side runners are so stiff they jam a lot when you try and slide them up and down. Apallingly made, machining is terrible all together garbage. To add insult to injury you can't contact the seller