HQPARRTS Leg Levelers Fit for Outdoor Camping Stove Explorer Stoves Expedition Stoves,For round stove legs with a diameter of 1.25 IN.Adjusts Legs Up to 3in on Uneven Ground, for 1.18-inch(ID) legs

Used on Camp chef Explorer stove / griddle combo... works great

I'm using this on a camp chef stove - we use it quite a bit when we are out with the scouts. The leg levelers make setup quite a bit easier - yes, the legs have thumbscrews on them already, but those tend to wiggle themselves lower. The adjustable feet are quite a bit easier to use.One note - it's quite obvious. We put in one foot peg before putting the pin through the screw threads. I guess we were just excited with the product, but take a moment to look and install the pins (it's hard to get those feet off just to set a pin). There isn't any instructions for this, but it is almost fool proof.

Arrived on time and in good condition. Work as advertised. Being plastic I'm not sure how long they will last as I use my stove on uneven rocky ground a lot when I am camping. I will have to see how long they hold up, but as for now, they are doing the job.

They did what they're supposed to do

These leg levers were easy to install in my new two burner Camp Chef camp stove. I was a little confused at first by the metal rods included in the package, but there's a little hole in the top of the foot piece they're meant to be installed in which will keep you from screwing the leg all the way out. I don't know that they're really necessary, but it could potentially keep you from unscrewing the foot out too far.My only minor gripe is that it could fit a little tighter in the leg of the stove. I don't think it'll come out, but for a friction fit it's not very tight.

works great

Very easy to use. All you have to do is take out your old plastic leg insert. Then push these into the legs. Helps a lot on uneven surfaces. A lot better than using a rock. They fit perfectly.

Don’t fit. To small. Just fall out when you pick up the stove.