Mowei [3+2 Pack for Galaxy S23 Ultra Screen Protector [Fully Support Fingerprint & S Pen] 3X 3D Curved Tempered Glass & 2X Camera Lens Protector for Samsung S23 Ultra 5G

Over the years I've tried many different screen protectors for my S21 Ultra, mainly the plastic film type. These were ok but often moved around on the screen, made the fingerprint sensor less sentive, made the screen feel soft and eventually would develop bubbles, tear and fall off. I actually thought a tempered glass protector wasn't possible on the S21 due to the curved screen - how wrong I was!This protector, after careful installation, gives you that glass feeling without compromising the fingerprint reader at all (I didn't even have to rescan and it works everytime instantly).The installation is tricky and the first one ended up slightly miss-aligned (a few rows of pixels at the very top were unprotected) but that package comes with three so I tried again and got it perfect on my second go. I followed the instruction video to the letter and had no air bubbles at all.Just take your time and pay attention to the video.If you have trouble with dust a trick I try is to run the shower on hot for a few minutes (with the door closed) then wait for the steam to clear - it will take any dust with it.

So, I have installed a ton of different phone screen protectors and I am usually the guy reading the reviews of those who have struggled thinking: "You didn't read the instructions, did you?" But this time it is me that everyone is thinking that about. Well, I watched the Youtube video before I started - I even found the right one for my phone as the QR code on the box takes you to a video for the wrong one - I assembled all the parts and made sure I knew what to do with them and then launched in and followed the instructions to the letter. The first screen splodged loads of glue all down the side of the phone, but I wiped it up and persevered. It lasted a day in my screen case before the entire edge started to lift leaving a line about 1cm wide right down one side of the phone. So I thought the cure times with the LED gadget provided must be a bit short so I had another go and left it a good while before putting it back in my phone case. All good - this one lasted a day an a half before the other edge started to lift. Third time luck? Err, no. Went nuts with the glue - it went everywhere down every edge of the phone - doubled the cure times and thought I had it cracked, but this time the same edge as screen number one lifted in just over a day, I have a Mous case which has been fine with every other screen protector I have used. To those of you who have had successful installations, hats off. To anyone thinking of buying, just be aware that this is a more complicated install than most and if my results are anything to go by, the average person can have problems. While they were on, the finger print reader worked well, they were super clear and easy to clean with a soft cloth. I didn't drop the phone at all in the period I have them on so can't vouch for performance in that scenario.

After dropping my phone twice, I had two cracks in the screen on my Samsung Galaxy S23 Ultra. I had damaged the top third of my screen with two cracks on both the left and right. On the left was a small but deep chip, and on the right was a large crack stretching from the top near the camera down by about a third of the screen and across to the right edge. I was considering sending my phone for repair but decided to give this screen protector kit a try first.The installation video explains exactly what to do and it helps to have this nearby on a laptop to rewind and pause as you apply the kit. Everything is included for cleaning, applying the glue and finishing with the UV light.The two cracks on my screen are completely gone and the screen protector is almost completely invisible, apart from a small lip at the very bottom of the phone. There are no bubbles, it applied perfectly straight thanks to the guide tray, and it's super clear. Once I re-calibrated the fingerprint reader, this works flawlessly and there is no impact in the touch screen sensitivity. I did not have to enable the sensitivity feature in the phone settings.I don't normally leave reviews but this kit was particularly impressive. To think I nearly spent £200 odd on replacing the screen when this kit cost me less than £20 and done the job perfectly is unbelievable. The camera protector is an added bonus and actually looks quite smart. You would think it was part of the phone's overall design.Would I recommend? Without hesitation.

I messed up the first kit as it felt that there wasn't enough glue (it left a space at the bottom) but the support team sent me a replacement. I realised that if I put a small amount of glue at the top, then it fixed the issue and I was able to get a perfect fit.You also get a nail curer, which my daughter nabbed after I had used the last protector.Overall it looks really good if you do it correctly and it's hard to distinguish that you have a screen protector fitted. The fingerprint reader works, but it's not as effective as when you don't have a screen protector, but it's a fair trade-off.It protected my screen from scratches and a few drops. However, I did end up getting a crack in the screen when I accidentally dropped it onto the foot of a metal office desk, it landed on the side of the screen. Oddly the screen protector was fine, but the screen on my S23 had developed small hairline cracks. However, I don't think that was an issue with the screen protector, more with the fact that S23 has curved edges which are an absolute nightmare to protect in the first place.