M6-1.0 x 25mm Flanged Hex Head Bolts Flange Hexagon Screws, Stainless Steel 18-8 (304), Plain Finish, Quantity 50

These bolts are highly magnetic - strong enough to stick to the magnet when held in the air. If they were the grade of stainless steel claimed, they would not exhibit strong magnetic attraction.

They look like they are good quality thanks

I bought these for a Land Rover LR3/discovery 3/Range Rover sport skid plates. M10x25 is the right size and it has the same 13mm hex head. It is a perfect replacement for LR part KYG500500 which is a stronger 10.9 hardened steel bolt but rusts like crazy on the underside of the car, these stainless bolts should be plenty strong(given I only had 4 of 8 of the originals holding it and they were heavily rusted and the bolt clips these screw into is where this fail anyway. These were around $10 for 10 vs. $7 for a single LR bolt, so $8 vs $56 for the 8 bolts required!

The media could not be loaded.  Using these to replace my rusty fender bolts on my old’ Nissan. These are a perfect fit.. but it’s odd how it’s metrik thread pitch but the head of the bolt is 5/16. The 8mm fits but it’s loose fit.

I would give a 5 star rating for the nut and bolt stainless steel quality.However, I would only give a three star rating for truth in advertising and size information. Average of 4 stars.The nut head size is accurate and uses a 10mm socket.The bolt head size is smaller than 10mm (5/16) inch so it does not match the 10mm and needs an inch socket to install.The advertisement said it is a metric bolt and it is not!It is very frustrating to need two size wrenches to secure the nut and bolt assembly!

I bought these for my 2011 MDX rear license plate bracket as the OEM ones were dusty. I had to buy 50 unfortunately, when I only wanted 4. Couldn’t find any smaller lots for stainless. Regardless, I’m satisfied!

I use serated flange head bolts on applications subject to vibration and heat expansion. A must for installing headers on aluminum heads There's some thread compound used on aluminum wire nuts to prevent electrolyses corrosion. Little dab of that stuff, your aluminum heads will thank you.

I got them to replace my 68RFE pan bolts. These was a little too long for the bolts that didn't go all the way through so I had to order a set of 12mm for those. But these are very nice bolts otherwise.

these are of high quality, well made, threads are well formed and installed in my lathe without issue. great value for this quality.

great stuff