WEILEITE Car Outer Window Molding Sweep Felt Trim Seal Weatherstrip Kit Compatible with Toyota 4Runner 2010-2021 Replaces 75712-35011 75711-35011 75722-35011 75721-35011(4PCS)

Exact match and perfect fit for my 2010 4runner limited. Helps prevent water, dirt, and leaves from falling in my door frame. Also, they are quite a bit cheaper, a fraction of the price compared to Toyota dealer/autozone/orileys wanted. FYI: My old ones were totally falling apart and were almost mushy.

Exactly what we were looking for. Our 2010 4Runner limited seals were dry rotted and cracked. These were the exact replacements and very easy to change. 10 mins total. Put the windows down and pull the old ones straight up. One small clip near and above the door handle. Well worth it.

I didn't notice right away because I wasn't paying attention to the clips, assuming that these were a direct replacement as advertised. After doing the driver side front and back, I started on the passenger side back window and realized that the OEM weather stripping has clips on the front and back but the replacement does not have clips on the front or back. This is also true for the front passenger side as well. The clips are not on the replacement like they are the OEM weatherstripping. I am unsure if the driver side had clips or not because I was not paying attention to the clips during the install and I am afraid to uninstall to check for fear of damaging the weather stripping and then having none to protect my car door inside. but the passenger side is confirmed not to have the clips.I am pretty sure this is just a manufacturing defect and not the actual product. However, removing the old weather stripping they have become damaged and cannot be replaced. And now I have no other stripping on my doors. So I'm forced to use these replacements that are going to be loose because there are no clips like the OEM.Seller, if you are reading this review please contact me. I would love to hear from you and hopefully resolve this with a replacement set with the proper clips.Update 12/26/2021:Customer service is amazing! they have reached out to me and explained that the clips most likely were damaged during shipping. After checking again, I can see that one of the clips was broken off in the box. I take back what I said about quality control as this seemed to happen after packaging. Seller has issued a replacement. My review has been updated from 1 star to 4 stars because of the amazing helpful customer service. If my replacement arrives with the correct clips, this will easily be a 5 star product! I will update again when the replacement comes in and see if clips are attached correctly.

The construction materials look ok, and you can't beat the price (you basically pay the same for all 4 pieces as you would for just one felt seal from Ford OEM). The problem is that only the outer seals fit in the steel door panel. These do require some trimming as they are a little too long on the wing-window side (careful not to remove too much, cut off a little and check fit), and an angle-cut is needed on door-jamb side to fit against vertical seal. This was not hard, any sharp sheet-metal snip or even heavy-duty scissor works easily here. Use your old seal as a reference. For the inner panels, forget it, these seals are totally wrong. The Felt is ok, but the clips are the same as the outers and on our 1994 F150 F150 inner and outer clips are not the same. I wound up prying off my old clips, cutting longer mounting slots in the seal with a chisel, and it was a real battle to get them on. I Don't plan to repeat on other side, will just buy the OEM inner door panel seal (they are sold individually) Overall, they're not bad deal for the cost if you know up front what you're getting into, but don't expect it to be a perfect product.

Lo utilice para lo,que fue elaborado es fácil de instalar

These did not fit right on my '94 Bronco at all. Had to be trimmed for length, wouldn't fit snug to door panel, and rubber pinches together and won't allow the power windows to roll up! I tried to trim and modify them, to no avail. Worthless.

I put these in my 94 f150 and they are a very tight fit. I almost wanted to cut a cm off just to give a little bit of room. They wanted to buckle up a little bit I’m hoping with time and heat it will seat night. Even with rolling up and down the window they don’t come out but it does make rolling it up and down a little more hard but it is doing it’s job.

Like many, I bought these because they were considerably cheaper than the OEM version. The installation was pretty straightforward, which was nice. The problem, however, is that one of the items was pretty gouged upon arrival. Additionally, and this is much worse, one of the clips will not stay in place. See photos. You get what you pay for, I suppose.

SON EXACTAS AL MODELO DE LA CAMIONETA F250 1993

quality looks good, and I would be happy if they fit, however the mounting clips are in the wrong place to work on my 1992 ford F 150. Destroyed the old passenger side seals getting them out and now I'm struggling to find the correct ones... and I procrastinated to long and too much time has past to return these.

Le quedaron muy bien sin ninguna modificación