Cruzix Sublimation Blanks Keychains Bulk, 200 PCS Keychains Ornament Tag Set Include 50 PCS Heat Transfer Double-Side Sublimation Blanks, Key Chains, Leather Tassels, Jump Rings for DIY Craft Making

It is a very good product, but you have to take into account the following information, a) give it a bleed of 2 mm, that is, its design must be 52 mm and not 50 mm-çb) your design should only reach 48 mm, so you do not run the risk that any information is lostb) Do not place thermal tape on the area to be sublimated, it will be marked. Therefore place the tape on the side that is not going to sublimate.c) From the bleed, place another 5 mm so that you can fold the paper and hold it to the side that is not going to sublimated) Saturate the design color in photoshop for crisp colors

Description needs measurements/size of actual disc. Not just the hole. Quality for sublimation is perfect if you follow instructions. Tassel however does not fit on keychain ring properly so it won't move around.

I was excited to get these and ended up ruining a few because I didn't know that there was a protective layer. After that user error was corrected I proceeded to sublimate the keychains and much to my dismay, they all have a chip off of the side. I followed the heat and time instructions listed on amazon.

I liked these keychains, they sublimated decent. I did find the discs to be thick. Perhaps they need to be. Over all, they are a good product. Remember to take the plastic protective coating off before sublimating haha... I don't think it states that on the product.

Works well with sublimation, good price. Only complaint is it takes longer to get the plastic off then actual design. Plastic seal on both sides and its very hard to tell if its off. I would buy these again and try to figure out an easier way to remove seal