Anina Antenna Ornament for 2011-2014 Toyota Sienna 86392-08020 Toyota Accessory Antenna Adapter Black Mount Radio Antenna Base Bezel

Direct fit. Easy to install

Fits like original at a fraction of oem cost. Quality feels great and hopefully will last a while. I used some wd40 on the edges to get it to seat properly as trying to press it in dry was a challenge.

This product fits perfectly on my 2011 Sienna. It takes 1 minute to install. The size is perfect, the quality seems very good, and it looks very durable. I recommend it.

Wonderful replacement part for your car antenna. Even tho this is an aftermarket product it is still made to fit and look exactly like an OEM part. Easy to install takes about 15 mins to remove old and install the replacement.

This replacement rubber is like the OEM product. Fits perfectly. Installation instruction 1)Unscrew the long top piece antenna by hand or use a crescent (adjustable wrench) to loosen the antenna and then remove by hand. 2)Open the hood and use one hand to hold the bottom base rod of the antenna. 3)Use your other hand with a mini plier to remove the old torn base bezel rubber piece. If it does not come off, you may need to use a small razor or box cutter knife to cut the rubber but not too deep. 4) Spray WD-40 on the inside of the new base bezel. 5) Insert the new base bezel into the hole and push with your fingers til the bezel sits in. To get the lip of the bezel to hook under the hole, use a non sharp object like a butter knife, or flat head screw driver and press the lip and push at the same time. slowly work a portion of it to get under the hole. The WD-40 should help to lubricate it and allow it to move smoothly. The bezel should flush tight against the metal part of the car with no gap if install correctly. 6) Once the bezel is seated. Screw back the top piece antenna and use your adjustable wrench to tighten a bit but not too hard.

This antenna base fit my 2014 Toyota Sienna perfectly. Easy to install and looks just like the original. Good quality and holds the antenna firmly. Very satisfied!

Fit 2014 Toyota XLE Sienna like a glove! Put a little dawn soap and water on it and push it on. Snapped right into place snug. A slightly smaller footprint than the oem...but that could be because the original was old and mushroomed out. Nothing that is very noticeable.

Works well on the 2011 Toyota Sienna to replace the Antenna Molding. Takes some strength to get it in there but was done replacing it in 10 mins. Looks good when it is done.

fits perfectly for my 2011 sienna

.

Muy bien el producto y enviado en tiempo. Podría mejorar incluyendo un sencillo instructivo de colocación.