Biantie La 4 Pin Led Strip Connector 10mm RGB Strip to Wire Connectors Unwired Clips Solderless Connection for Multicolor LED Strip Lights 12V 24V (Pack of 10)

Worked great. Easy to use, and repaired my problem when the wire pulled loose from the light strip I used for the under carriage lighting on my golf cart. No soldering needed!

These were perfect and seriously a breeze to use. I've been installing LED's around my home and I wish i noticed these earlier. One tip I have for everyone, no matter if they use these or any type of connector. I always test as I go to make sure the connections are stable, as you should. Once I know they are secure, I further secure them with electrical tape. This will also keep things from getting lose if you move anything around.

The connectors function well when assembled properly. There is a key assembly note that the user should be aware of. The LED strip should only be installed with the copper connector pads on the side of the connector with the pins. Even though the pins will puncture the LED strip from the other side, they do not made good contact in that manner.

great product

I used 6 of these with LED 4-conductor ribbon cable to bridge the gaps in my lighting scheme and all of them worked fine. If the wire side is closed when you get them they can be a bit difficult to open. Pry along the saem with something narrow like a jacknife blade and they will pop open. Use pliers when closing them to make sure the metal prongs bite into the wire.

First, I thought this included wires from the product images. Second, I have a Zigbee controller but Govee lights and so instead of buying a new LED strip, I decided to use these to adapt the pins to wires. This solution barely works. The connection is way too loose which makes it barely work.

They are pretty much easy endless you snap them before you use them buy accident cuz they will never unlock. Order extra if you need them like with every project in life.

After you separate the wires a tad, they just slip in. You do have to make sure you don't push the light strip in too far. They do ruin your nails prying them open. I gave adhesion one star because they didn't come with any kind of tape.

Happy

I like the channels to insert the wires but the connector by itself is cheap. If you press too hard the junction at the middle breaks and the connector is scrapped.

The connection does not work well and if you even look at it wrong, stops working. I had to replace the led strips where these were used on because it shreds the strip. I ended up soldering all the connections instead. Would not recommend.