SDS Spiral Mixing Paddle Paint and Mud Mixer Mixer Whisk for Drill in 1 to 5 gallon buckets Fits all Standard (size: 4 inch x 20 inch, around 100mm x500mm)

Great tool. Some areas are very tight and therefore will trap unmixed sand/thinset/grout. Mixes mud very well. No sharp edges that will scrape and cut shavings off bucket, therefore no contamination on your mixes. Perfect length up to 6 gallon buckets.

Used this a lot over the last few months and it hasn't buckled or bent yet. Pretty easy to clean so long as you act quickly... spray it with a garden hose as soon as you finish mixing and you're good to go.

I m8x buckets of concrete with it and if you put on reverse it stays in bucket. I love this wand. It's tough and well worth the money

Justo lo que necesitaba. Tal cual la descripción

See picture. Gray bit on the right fits my drill. Goldish shank on left is this product as shipped. Groove is too narrow and too shallow to lock into my SDS+ drill. I took a chance with my dremel tool and ground on it enough to get it to fit. After modification it worked to mix up 50 lb bags of tile mortar in a 5 gallon bucket, but would’ve been useless to me as shipped. Decent enough product but did not work without modifications

I used it in a tub to mix water into a cement and sand mix for landscape curbing. I used one 80 lb. sack at a time. It did a great job of mixing everything together. My big drill was a sds drill so I needed a sds shank on my mixer. It worked great!!

Fits in my ryobi rotary hammer. Kind of a niche tool. If you have a tool that has an sds chuck, but no tool with a large enough chuck to take standard mixing bits, this is the one for you. Save a few hundred bucks.

The ball detent slots on the shaft are too narrow and shallow to allow a standard SDS+ collet to close and lock into place to secure the tool. It just falls out. Guide slots are different width from each other as well which makes zero sense. Just poorly made.