Walker 36326 Universal Universal Exhaust Flex Pipe 2.5" Inlet (ID) 2.5" Outlet (ID)

Simple. Bendable and can stretch--however sturdy and solid.I got a new catback exhaust--however at the shop they said it wouldn't fit. I tried myself but I could not get the mufflers in properly. I thought I'd resort to this option, GREAT MOVE.I bought 2 of them, both came in a box and came with a clamp and hardware. Great quality all around.I was able to connect both to the Y-pipe, and they stretched to the duel conversion pipes and worked like magic. I had to pull and bend to fit them after I wrenched them tight--didn't budge. They fit perfectly (2.5 in.). Worked wonders and I was able to complete my project with ease and at a very fair price. I referred a buddy to use them. Would buy again, 5/5.

I bought this for my 2012 dodge charger, it was a really tight fit but fit perfectly over exhaust, its allot more sturdy then i was expecting and offers just enough flex to make this slight turn in my exhaust, only thing i dont understand is why it only comes with one clamp, i had to buy another clamp which was cheap enough.

Good cheap fix

I used to to patch a broken exhaust pipe. It worked well. It's a great temp fix till time and money is available.

I purchased this product after the catalytic converter was stolen off of my truck. Some things you should know.Very sharp burrs - I believe these were cut with a bandsaw with a feed rate set too high. This coupled with the fact that it is relatively thin material, resulted in very sharp burrs around the cut edges so beware. Also they were not cut straight.Length significantly shorter than advertised - I purchased two 18" pieces. One measured in at ~17 1/4". The other at ~16 15/16". Over an inch under. Now I will have to figure a way to bridge the large gap that I did not account for because I did not expect to receive them so much shorter. A minor inconvenience for me, a little variance is expected but an inch short is completely unacceptable. Did they just eyeball it?One clamp - Each tube only came with one clamp which is a bit odd since it has two ends? Also beware of metal dust, there was a lot in my box.Aside from those issues the material itself seems quite sturdy and it should do the job just fine once I bridge the gap. And at a reasonable price. All in all a good product if you are expecting yours to be an inch short.

As advertised

Product had a side cut about 2 inches deep making 2 inches of material useless, where it was cut wasn't straight and made the layers unravel once that cut cut and removed I was left with now a piece that was too short. Also it doesn't bend much, not enough 40 degrees of motion over a foot. Purchase elsewhere.

The part is the best for my swap