LavaLockRTV High Temp BBQ Smoker Sealer Gasket Adhesive 10 oz Cartridge (450 F - Black)

If you smoke food and have inconsistent temperatures, then try this. Easy to use, cures fast, and holds up to high temperatures. I used it to prevent unwanted smoke loss, and I have been extremely pleased with it.

I used this to hold a new rope gasket to one of our Big Green Eggs. I tried a different product and didn’t have very good results. This is really holding up.

5 stars! I've used this product before after assembly or down the road when I noticed my grill or smoker is loosing smoke/air or temp. I just got my oklahoma joes bronco and while I assemble it I used this sealant to ensure from the start I'm going to be 100 percent sealed where I want and need to be. It sets up quick and cures fast follow manufacture instructions and you will be good.

I bought this to help seal my smoker. I was very easy to apply, just have cleaning clothes ready to clean up. I cut off the cap and screwed on the nozel, it came out in the volume I wanted, I just took my finger and smoothed it, it comes off easy. Will see how well it seals once it's cured.

It works but I got it everywhere lol that's user error for sure. After some clean up it looks great as well.

I purchased a vertical offset smoker. The firebox had a large gap going into the cooking chamber. Too large for a stick on gasket. This sealed it off no problems. Would heat cycle it a few times before cooking. So the aroma of silicone is not mixed into your food.

Great product. Went on just fine. Make sure to clean surface of grease and moisture before installing. Don’t listen to bad reviews on the caulk tube: they just aren’t used to this newer style of tube. It’s actually the nicer type of caulk tube outlet, you just have to know what you’re doing. I’m a pro tile installer so I’m familiar with them. When you are nipping the end of the outlet for caulk to come out, BARELY shave off the end with a razor or fine tooth hand saw. Shave or cut little slices until you reach the opening then STOP. If you go further and cut away the first line of threads, of course your nozzle will fall off. Once you know, you know. Then you can replace the nozzle if it gets clogged before your next use. Its for convenience. Just don’t be all crazy with your knives 😜

Used it to sell the seams on a pellet smoker. Stays tight and does not appear to be affected by high temps.