Campbell-Hausfeld RE300000AJ Regulator for Air Compressor

This regulator works great, just remember to order the right regulator, check the flow of the air coming from your air compressor tank and where you connect the hose to run various air tools. As with mine I needed the middle port to put on my air gauge . Please take note as to which way the air flow goes to determine which regualotor to buy. All regulators have an arrow on the regulator to tell you which way you have to install it. Same regulators have a different set up as to which way the air will flow and the position of your air gauge. Pay attention !!!

Well, it was a cold dark night in my garage. I was finishing up some powdercoating and about to drain my compressor. The hose got stuck on something while I tilted the compressor back and BANG!!! pieces of the old regulator exploded like Rosie O' Donnell at an all you can eat buffet.Checking myself for shrapnel wounds, I finally found the old regulator broke off and shattered in a lot of pieces. This replacement is an exact fit for the old one and worked out well for me. Just a couple wrenches, some teflon tape, and I was back in business.I recommend this regulator for any of the Husky compressors.

Mine leaked. This was an adequate replacement, although I'm not sure it was new. Looked a little beat up. It was just in a plastic bag, so maybe from being jostled around during storage and shipping? I don't know. I needed it and it worked.

When I went to change a leaky valve on my compressor the original regulator just exploded. This arrived quickly, bolted right into place and 2 and a half years later is still going strong.

This valve replaced a 30 year old valve that started to leak, it looks exactly like the original and works fine.

Replaced a Porter Cable regulator with this one. The original one required too much turning to adjust pressure. This one is fast and accurate. I have this model on another compressor and liked the way it worked, easy to adjust.As pictured, air flows from right to left with 1/4" inlet (right) to 1/4" outlet (left). Top 1/8" female is for regulator pressure gauge.

Not as advertised. Knob has no red (or otherwise) decal with arrow, plus, or minus. as shown/implied on the advertisement. Made in Tiawan, not USA. If it does not work properly, I'll be returning it for a refund. Why show an original Campbell Hausfeld product in the ad, and then not send buyers one??

Part received was a pressure regulator but not from Campbell Hausfeld as advertised. Used it anyway and it appears to work correctly. Rated a 3 for not receiving part advertised.

it regulates 90 psi very well.used for CH compressor.

Like it fits works 👍

REMPLACE BIEN LA PIECE DEFECTUEUSE

very pleased thank you

We substituted this one for the original one that was available because it was less expensive. Although it looked a little bit different, it did the job, and the air compressor works like a charm again and we’re all happy!