RJ45 Cat5 Cat5e Pass Through Connectors Pack of 200 | EZ Crimp Connector UTP Network Unshielded Plug for Twisted Pair Solid Wire & Standard Cables | Transparent Passthrough Ethernet Insert

REVISION: The initial poor review (below) was 100% due to my error. The connectors DO work well. The pass-through design is WONDERFUL.My error: I got lazy building Cat 5 cables and didn't always bother with the 'crossover protocol' and simply went with pairs of matching color wires on both ends of the cable. THAT DOES NOT WORK WITH CAT 6 WIRE as I discovered after wasting a few hours thinking it was me, my crimps, the plug design, etc.In short, be sure to follow the recommended wire color order (which involves a 'cross over' of the blue and green wires). I finally did as I should have done all along, and voila! We have excellent connectivity.-------------- INITIAL REVIEW FOLLOWS ----------These plugs made it impossible to get a good connection when plugged in to the router/switch/pc on one end, and the other devices (cameras) on the other end.We built 6 cables (12 - 14 ends) for a camera system. Not one cable successfully brought the camera online. We cut off a few ends in case it was my fab error. It was not. .I've used other pass-thru RJ-45 plugs that were a joy to work with. The pass-thru idea is wonderful and can give high degree of confidence that the wires are (1) fully inserted, and (2) entered the correct channel for each color.I am not a down-grader normally, but these couldn't earn more stars than I've awarded.PRO TIP: be sure to leave extra wire length to work with and 'comb out' straight. Then, pull them all the way until your rubber outer coating is deeply embedded into the end so the clamping action really grips well and gives you good strain relief.

These are awesome. You can easily see the wires are inserted correctly and then slice the excess off. Make sure to have a precision cutter (exacto knife, precision diagnal cutters, razor blade). you have to make sure the excess is cut as close as possible so when the end is plugged in it will go in far enough to lock.

Good quality no issues

These cable ends function very nicely. I am quite impressed with how securely they grip the outside of the cable! Tip for users who do not have a network tool with pass through cutters... cut your wires a little on the long side, pass them through, trim them with flush cutters, then push back into the connector.The only con is that these ends are perhaps a shave large and fit too snugly into ports. Perhaps it is an issue in molding because I only have that issue with a couple ends, but cannot confirm if they all do this or if it is simply the fit in my ASUS router.

Good quality, ran new Ethernet throughout my home along with Poe cameras, all of the jacks spear have worked perfectly fine, the pass makes it nice and easy to wire it up just right so when you clamp it’s on the sleeve.

I used one with my Klein VDC226-110 crimper. Worker fine. So far so good.Much cheaper than the Klein plugs.

My Son In-law had some other version of these however I was having a hard time with them. I am very pleased with these as they are much easier to work with.

They work great. This is my second order the first order every end worked without a problem.