Spal30100374 10" Straight Blade Low Profile Fan

The Spahl 10 inch straight blade fans performed well used as a pair of pusher fans. They were used to feed air to my main puller fan. For the dimensions I had to add auxiliary fans they were perfect. Fan noise barely noticeable over engine noise. The Spahl wiring kit kept installation manageable.

Little sucker moves some air! Leaps and bounds higher quality than the crappy aftermarket fans out there. Pulls some amps and blows some air. I highly recommend Spals. Using this 10" puller along with a 12" pusher in my Datsun 510, cools like a beast.

Powerful for a small fan. My Blazer would run just a little hot in the summer while stuck in slow traffic. I installed two of these(no room for bigger fan). I can watch my coolant temp drop 10 + degrees within a minute when I switch them on. Also it helps the AC cool better.

This not a "puller fan" as listed, it is a "pusher". The 30100360 is the same fan but is a "puller". Check the specs on the SPAL webpage for the fan you need. The product is fine, I have used many SPAL products, but if you want a "puller", you will be sending this one back.

Good CFM Considering the small size.

High CFM.. HIGH QUALITY

Works great

I purchased this fan because the ac condenser on my Miata would get too hot during stop and go traffic and it would cause the ac compressor to turn off under high pressure until I could get moving again & the freon in the system cooled down..."problem solved " with these fans....I now have a 10 inch & 7.5 inch spal fans pushing air in front of the condenser in combination with the two factory puller fans pulling air through the back of the radiator.