Uniflasy 7635 Flavorizer Bars and 69785 Grill Burner Tubes for Weber Spirit I & II 200 with Front Control, Spirit E210, E220, S210, S220, for Weber 15.3 Inch 7635 Flavor Bars and 69785 Burner Pipe

The quality of these honestly surprised me, obviously good metal and quality construction. Everything down to the tabs for igniter mounting, airflow etc all in place and well done, and what a deal to come with new heavy duty coated flavorizor bars. Metal thickness and fitment were great, I had no problem installing with provided hardware. I’ll be recommending to the boyz

Fit well and does the job (Weber Spirit E210). The original burner tubes have a small notch on one side where they anchor under the screw in the back. These replacements do not, so they sit out a little further than the originals (they bump into a small protrusion on the cast iron body of the BBQ), but seem to remain under the screw (if the screw is rusted in place, as many are). All in all a good purchase! But definitely watch a YouTube video or two - installation is much simpler than depicted in the written instructions that come in the package!

Not sure of longevity as I have only had for a couple of weeks now. I use my grill almost daily and these burners seem to do the job. They replaced 8 year old OEM burners. I hope they last like OEM did, but price is great. Installed easily, but I did have to drill out a screw to remove the old burners. That’s no fault of this product though. I definitely recommend. I bought “used” and saved money. They weren’t used at all. I’d say someone ordered the wrong burner for their grill and just returned. I’d buy the “used” again.

Fit Weber grill well, o problems, appear to be more robust than originals.

I have a Weber Spirit E310. I rarely have have to replace any parts because Weber simply makes good products. The burners will wear out eventually on any grill and it was time for me to replace them. I looked at OEM, but they were 3 times the price. From what I can tell, these are similar or maybe the same as the OEM ones I took out. The fit was perfect and they appear to actually be stainless steel. Some product descriptions that claim "stainless steel" are absolutely false. Like painted steel is stainless steel... nope. Or galvanized steel is stainless steel... nope. These appear to be actual stainless steel. Now for the installation tip. I think Weber could improve their design of their grill. Burners will wear out and need to be replaced so why use a flimsy screw to hold in the burners??? Mine were rusted and couldn't be removed with out drilling them out. That's a huge pain and most people just don't have the tools to drill out and remove a rusted screw. Instead, leave the three screws in place and slide the burner under the existing screws. The kit comes with new screws, but I absolutely could not get my old ones off. Removing the front cover isn't too bad. Just pull the knobs off. Remove the screws under the knobs. Pull the two wires from the ignitor, undo the 4 screws holding the front plate on and finally, remove the two bolts that hold the front panel bracket. There are some videos on how to do this. I just figured it out as I went. Hope this is helpful. I've only done a test burn at this point. I'll know in a few years whether buying non-OEM was a good idea or not.

Easy install and work great!

These were a great replacement burner for my Genesis Silver B. They install just like the factory originals and seem to be comparable quality. I've had mine for a couple years now and expect them to last for a long time. Heating is nice and even and I haven't had to make any adjustments after replacing my factory original burners.

Works great.