Wolfride 1/4-Inch Shank 90 Degree V Groove Router Bits Round Nose Bit CNC Router Bits

Great value for a set of "budget priced bits".

They come in nice little separate storage tubes. Seem to be sharp & of good quality.

Muy util

I only used these to create a short groove, so they did a good job for that. However long term use I can't remark on that.

They DO cut, but they go full very quickly. I purchased them for a quick project so they were “convenient” but they are not very high quality.

Router Bits for Juice Grooves on cutting boards

They did the job. Cut about 50 linear ft of alder with the 1/2” bit. Started to dull from the heat at the end. Got the job done though.

I ordered this set to work with my engraving kit. Found the bits to be long enough to use with a guide which many do not. Bits cut through the material well, no need to go back over them again.