E144D Elite 144 Site Aeroponic Cloner with Humidity Dome & Klone Collars

Very easy instructions and simple to assemble. The TurboKlone did arrive with two broken sprayers, which was disappointing, but other than that assembly was incredibly easy. I did have a slight warp in my basin which led to some water droplets coming out with the fan running. I simply took a small piece of foam and set it in the gap and poof, no more drops. The fan is loud on this thing, which you might expect with the high CFM, but it's the one thing I'll likely replace. The humidity dome was an absolute must for me since I'm cloning tropical plants instead of growing weed like everyone else. Overall, very happy with the unit.Side note: Anyone whining about the cost should look into the cost of having a custom molded two piece basin made. It's pretty dang expensive and will probably make you appreciate this unit a lot more.

So far this I've had it for about a week and had it running as long. The only two issue that seem apparent is the humidity dome come sized to the machine, but immediately starts to warp and become misshapen on the machine. The dome so far stays in place as it should, but the sides puff out and are not touching the machine so there is airflow into the clones that shouldn't. I worry that in another week or two, that the dome will warp too much to sit properly on the machine. The second issue is the fan that attaches to the side of the machine seems to do about nothing. The water inside stays about the same temperature with or without the second external fan running so it really just adds to power use for little to no gain.All that said, this machine so far seems to be decent, although I will also say the product went on sale for like 75 bucks cheaper, less than a month from when I got it, and the sale price is probably a more fair price than 500 bucks for plastic that warps so quickly.

The fan died almost immediately, not a huge deal because they are easy to replace. I measured the voltage of the power adapter. It's supposed to be 12V to match the 12V fan, but when I tested it with my meter it puts out 18V even though it says the on the adapter that yhe output is supposed to be 12V. It you buy this measure the adapter voltage before plugging in the fan. Chances are that the adapters are faulty or incorrectly labeled. Otherwise I like the product.

Pump on cloner failed right out of the box and killed 144 clones. Smh. Turbo klone used yo be a good product as this is my third kloner from them. Never again turbo klone from now on its ez klone for me.

Love all of it except the key hole knobs broke installing the motor.

My only complaint is the humidity dome is not properly sealed on the bottom, gaps in front and back. I'm not sure if it's defective or all of them are like that.

the best i have ever used