The ROP Shop | Check Valve Repair Kit for Homelite 308653052, 308653007 Pressure Washer Pumps

These valve assemblies were a perfect fit in the pump of a Ryobi pressure washer, although they were actually listed for use in a Homelite one. The silly folks who made the Ryobi unit didn't even list these valves on the parts diagram...probably because they would rather have you buy a complete pump than a few low-cost parts to repair your existing one. Outsmart them and do what I did...you'll be back in operation in no time with hardly any money out of your pocket!

Nothing wrong with the it

These valves are superior to the ones found in a HF Portland 1750psi electric pressure washer, but are not exactly the same design. I thought they'd fit being the same size, and that is true for the three that reside in the pump head. The OE design seats on a rubber o ring, resulting in the plastic deforming through the head's water intake holes under pressure. The new design seals around the bore instead of the base. They seat properly in the *head* part of the unit (3 holes in a triangular pattern), but not in the side unloader valve portion. They sit too high and wont' seat. Luckily I still had 3 good ones I could swap around, otherwise I would have had use a mill bit to open the unloader casting holes (second photo w/ 3 holes in a line) by a tiny amount. My advice: Disassemble and inspect first.

It was a perfect replacement part for OEM check valves

Great for both my 3300 and 3200 psi craftsman pressure washers

It is ok did not find but still a good product

A perfect fit. A little push with a dowel and they seated perfect

Good productInstall it in 30 minutes and you're donenow I have back my pressure washer ready to use