Creality 3D Printer X Y Z Axis Stepper Motor and Limited Switch Endstop Cable for Cr-10 CR-10S CR-10 Mini (Pack of 3)

Well the wires are as you would expect. XYZ axis plus E motor wires. The sheathing on the cable is a little skimpy. I think the sheathing could have cover a lot more of the wires. I used this for a dual Z upgrade on an Ender 3 Pro. The cable for the Z axis is really long for the Ender 3. I mean really long. It works though. I guess better to long than too short. I cant really complain because I'm using it unconventionally. It's good to know it works though.

Also work for the Ender 5 and 3 Pro, I bought them as longer spares in case of failure, which did happen on the x axis on my Ender 5, swapped it out for the one here and working great.

These longer stepper and stop switch cables are working perfectly on my ender 3 pro with an external controller box

Very handy, enough length for all 3 cables so I can move the controls & main board outside of the unit

The media could not be loaded.  Horrible. Extruder cable wired BACKWARDS!When I extrude, the backwards wiring causes my extruder to retract INSTEAD of extrude. I’m warning others to stay away from this product on all my social media pages. Soo inconvenient.

Creatlity commented on a question saying these are actuallyX:920mmY:780mmZ:780mmI thought these where:X Axis:750mmY Axis:420mmZ Axis:180mmThey will work for what I need, but it's wrong. They should update their page.

these cables and splitters keep my zed axis perfectly level and no more broken wires?

Exactly as described good cables

My E3v2's extruder cable went bad. Got this and simply replaced the whole set of E, X and X-switch wires. The length is a bit longer but I think it's perfect as it gives it more freedom to move.