VXB Brand 1000 lbs Capacity 12" Lazy Susan Bearing 5/16 Thick Turntable Bearings Made in USA 1000 lbs. max 15" inch to 30" inch Turntable Diameter Zinc Plated

good

I have a large Qidi X-Max3 FDM 3d printer. The filament is mounted on the back and so I wanted a better way to access the rear of the printer without having to bust my back moving it. I made a turntable out of this Lazy Susan and a piece of plywood and bolted it to the bench. The installation was very easy and it does what I want it to do! Highly Recommend!

Was disappointed that screws didn't come so I could fasten it to the wood to make a lazy susan.

I bought this for the extra tall, spinning dvd/movie/cd rack. It if a huge improvement over the plastic one. It didn't come with any hardware which is fine, I had some laying around. I used a tape measure to get it as centered as possible. But the unit still seems wobbly? I don't know how to fix it. I'll need to ticker with it. But it's a vast improvement over the plastic one.

This product is exactly what it purports to be. It is a low cost 12" diameter Lazy Susan bearing. As such one cannot expect it to perform like a higher quality equivalent will. It is functional and works well. However, as reported by others, it is noisy. So, if your application is to turn your favorite rocker or recliner into a swivel version of same, don't be swiveling back and forth during your favorite TV show. Also, be sure the surfaces you are attaching it to are perfectly flat. If not, you will be warping the bearing as you attach it and then it will not rotate smoothly, if at all. In my project the bearing sits between two pieces of 1/2" plywood and carries a load of perhaps 75 pounds max. In this case it works well, rotates smoothly, and is noisy. Fortunately for me, noise is not an issue. If noise is an issue for your project, you will be better served by searching for a higher quality product.

Great quality. Works as intended

Better than the one that comes with original purchase

Be nice if I had instructions and hardware to install to my DVD case. I really can't give a proper review.