eSUNPLAPlus Filament, Olive Green, 1.55 kg

Exactly what i was looking for, i use a print glue when printing, and realy pleased with my biggest print yet. Is also less brittle than the closest colour i was previously able to find 👍

This is a 1kg spool not 1.55kg as stated in the advert, despite this it is good quality filament.

Updated:After replacing some extruder parts it prints like it supposed to. It probably was worn out extruder gear in combination with overheated bowden tube which was causing failure to feed. Other filaments still worked for some reason but eventually they also failed.There is no way I am leaveing bad review posted knowing it wasnt eSuns product fault.Like I said, 3D printing is hard.Original:3D printing is hard. There are so many variables, one can never be sure of cause of failure. With eSUN PLA PRO I am out of ideas and throwing in the towel. I did sever attempts at different settings and all prints failed with clog like symptoms. I have changed the nozzle, adjusted bed level hoping Im too close on first layer, changed temperatures from 225 down to 208 in some increments, and heated chamber temp 50C to 35C and to open door ambient, all with no difference. Prints were failing within first hour, mostly about 20 min in.Once I gave up I loaded up a roll of Polymaker PLA Pro and, without touching any settings, I did successful print right on first try ( 208C/60C 50mm/s ).Im not going to say eSUN PLA is no good. But it did not work for me at all while other filaments didMy equipment:Ender 3 with swapped in Creality direct extruderCreality tent300W lamp with thermostat

It came well wound and sealed, and prints well at recommended settings on my Ender 3 S1 Plus. I've burned a roll of the stuff over the last couple days and encountered no issues with the filament itself. It seems to even have decent moisture resistance as I left the spool on the holder for quite some time during idles and didn't encounter any moisture popping or weird bubbles on my prints.Color is classic ODG, gods favorite color, and is a decent match for the olive drab found in say some sun bleached old M81 BDUs or a slightly faded ammo can paint job. Finish is matte even on very smooth parts, perfect if you don't like the shiny plastic look.

I wish I could get more for this price

The media could not be loaded. Good color for military type prints. I printed this Mech, Madcat/Timber Wolf for my son. The supports are still attached.eSUN always prints very well.

Esun pla+ is worth the extra money!!!