GTZCat5e RJ45 Pass Through Connector 100-Pack - EZ Cat 5e Pass Through RJ45 Connectors - Cat 5e Connectors - Ethernet Connector, Ethernet Plug - for Solid or Stranded UTP Network Cable

Good quality no issues

My Son In-law had some other version of these however I was having a hard time with them. I am very pleased with these as they are much easier to work with.

REVISION: The initial poor review (below) was 100% due to my error. The connectors DO work well. The pass-through design is WONDERFUL.My error: I got lazy building Cat 5 cables and didn't always bother with the 'crossover protocol' and simply went with pairs of matching color wires on both ends of the cable. THAT DOES NOT WORK WITH CAT 6 WIRE as I discovered after wasting a few hours thinking it was me, my crimps, the plug design, etc.In short, be sure to follow the recommended wire color order (which involves a 'cross over' of the blue and green wires). I finally did as I should have done all along, and voila! We have excellent connectivity.-------------- INITIAL REVIEW FOLLOWS ----------These plugs made it impossible to get a good connection when plugged in to the router/switch/pc on one end, and the other devices (cameras) on the other end.We built 6 cables (12 - 14 ends) for a camera system. Not one cable successfully brought the camera online. We cut off a few ends in case it was my fab error. It was not. .I've used other pass-thru RJ-45 plugs that were a joy to work with. The pass-thru idea is wonderful and can give high degree of confidence that the wires are (1) fully inserted, and (2) entered the correct channel for each color.I am not a down-grader normally, but these couldn't earn more stars than I've awarded.PRO TIP: be sure to leave extra wire length to work with and 'comb out' straight. Then, pull them all the way until your rubber outer coating is deeply embedded into the end so the clamping action really grips well and gives you good strain relief.

Good value and works great!

This is one of the best inventions of the 21st century. HOWEVER, you do need a special pass through crimper or you can do like me and cut the exceess off with a box cutter, takes a bit more extra effort and time when crimping but I don't crimp a lot. Also make note that cat 6 and cat 5 cables function differently when it comes to RJ45 ends. Do your research and you should be fine. I used cat 5e cables mainly so no problems, I think cat 6 is slightly bigger and will give problems to fit into the cat5 RJ45 ends.

works as expected.

These through-connectors work well. The internal wire guides nicely separate the wires and channel them to the correct pins. If a wire is mis-routed, it's easy to see and correct prior to crimping. Connectors fit correctly into switch/router ethernet ports. Definitely worth looking at. BobM

Excellent Product