Pressure REDUCING Valve DZR Brass C/W Rear Entry Gauge 15MM 1-6 BAR PRV

The incoming water pressure has always seemed high, garden hoses leak at the connections and burst if left connected.Now that I've set it at about 2 bar, (after some experimentation), which is slightly lower than recommended, the benefits are apparent. The hoses don't drip at connections, and our mixer taps are for the first time able to properly mix low pressure hot water with the mains cold.This was easy to fit between the two stop taps onto 15mm pipe, using the supplied 22mm reducers, after moving the position of the water meter along the pipe to make room.It may take slightly longer to refill the toilet cistern/washing machine/kettle etc, but the higher pressure before was too much. I should have fitted one of these years ago, and now a few months on happy to give a positive review.

Good value and does the job.

Easy to fit and adjust pressure, job done.

Bought for my camper as pump pressure was too high for heater. Set pressure turned on and worked perfectly.

Used to lower excessive pressure, to protect combi boiler

I used this to reduce the water pressure to a number of garden hose and taps, previously the pressure was so great it blew the push fit hose connectors apart, now all is good, it's adjustable so you can get the pressure just how you want it, Great value also.

Works perfectly fine I use it to reduce the pressure to my Hozelock irrigation drippers

Easy to instal and has done the job I needed it for reducing my water pressure to 1.5bar