96W Dimmable LED Driver, 24V Triac/ELV/MLV AC to DC Power Supply for LED Light, Halogen Bulb, LED Transformer Compatible with Lutron & Leviton Dimmer, for Indoor/Outdoor Use

LED driver worked very well. Very smooth dimming The housing is very well made and seems to be of high quality materials. It was not easy to find an item of this quality for this price point. This box meets US electrical code standards because it has the high voltage encased inside the box. It also has mounting points which are important so the box is not floating around inside the wall or inside attic space. I bought this for renovating a bathroom and doing some high quality FCOB LEDs and it worked out perfect for my needs. I plan to do my office next and will be buying another one.

I purchased this to add dimmable under cabinet lighting to our remodeled kitchen. Very easy to install. Make sure you purchase the proper type dimmer switch to use with it. They include a list of numerous compatible switches that you can use. Very thoughtful! It works great and the results are fantastic!

Review for an LED dimmer/driver for 24v LED strips.Had a really nice LED strip (Joylit 24v LED strip, super bright, B0C1YZ55WY) that wished to have a dimmer running it, and wanted it as a permanent install so, dimmer switch needed to be the in-wall type. Further, the LED driver needed to be dimmable on the 120v side (since Leviton/lutron dimmers are normally for mains voltage). Thus the need for the dimmable LED driver (sometimes you will see the term Triac, or magnetic dimming). This is the unit for you.First the basics. Came decently packaged with a registration card. The unit has 1/2" knock-outs on both that back and sides of the unit. I did use NM clamp connectors on each side to secure the wire on the final install.Wires themselves were probably 16 ga (the ground was 14 ga). I used Wago's to do my connections. The low voltage wire was 18 ga (all guessing approximately). The lid snaps down tightly when you are done with the initial hookups. Unit never got "hot" when using.Used a Leviton 6674 (B0076HPM8A) sliding dimmer for the control of the unit. All worked flawlessly. No hum from the power supply unit (although it was behind a cabinet wall), and dimming was good. Was it 0-100%? not quite. I would probably say it went from 10% to 100% without issue.All in all real happy, would definitely purchase again.

Replaced a 300w transformer and five 50w bulbs to this 60w LED transformer and five LED bulbs. Works great, and much more energy efficient.

I use this product to replace an older transformer for my undercabinet kitchen lights. It’s pretty efficient, about 5W for the device.One design flaw is that the black coating on the box prevents the included ground wire from making contact with the box. It also prevents my BX wire from grounding to the box. I scraped off the black coating under the ground wire and around input power. Verified with an ohm meter before and after that this worked.Also when you’re working on the wiring, the door flap keeps getting in your way. I wish it stayed open or could be removed. But when you’re done, it’s nice how it snaps closed.

The driver dims perfectly and without making any noise. Works great with Phase cut dimmers.

The driver is great for using existing switches and dimmers with low voltage wires. I placed this where my microwave is plugged in and ran wires discretely for under and over cabinet lighting. Using a switch on the wall with a dimmer was exactly what I was aiming for rather than a remote control. So for it’s working perfectly.

Not much to dislike. It’s build well, several mounting/installation options. Well sealed from the elements. The conduit knockouts into separate chambers for the power in and out are nice. No flicker or anything. Really nice power supply. Almost no noise, doesn’t seem to run hot though I’m only running about a 2.4 amp load.