Justech 4 PCS 12LEDs Motorcycle Indicators Amber, 12V Flowing Turn Signal Lights, Motorbike Turning Indicators Led Turn Signals Kit Blinkers for Motorcycle Motorbike Scooter Quad Cruiser Off Road

These are really cool! Very bright and easy to see and the sequential blink is AWESOME. Easy to install I didn't even have to cut any wires just plug them in. Super sturdy you can bend them all around and they just pop right back into place .

I got these for my KLX650R dualsport, which is street legal in Nevada and has a full lighting system. I replaced some Bikemaster aftermarket LED turn signals that are better suited to a street bike. The Bikemaster turn signals had a plastic lens cover that could knock off under impact, and the lens was not well sealed and dust could get in. Anyway, I did a 450 mile weekend offroad ride with these and went through plenty of brush. So far, so good, the turn signals sustained no damage at all. They are also brighter than the Bikemaster turn signals. The only knock is that the backing nut can get loose. I will probably put a lock washer under it, or replace the backing nut with a nylon locknut.

Good value, works as expected. Pretty bright for size and low profile. They can be pretty fragile. If you need to secure it tightly to a mount, I’d recommend threading a nut on the inside against the rubber to tighten the outside nut against. Otherwise, if you tighten the outside nut too much against the rubber, the glue will fail and the light will be left dangling and you’ll have to glue it back together. Some peoplereport that not all the lights in the sequence light up. This would be because the turn signal relay is set too fast and the signal starts over before it finishes. For this issue, try getting an adjustable flasher relay to set it correctly. The wires are also a bit short if you have to reach across the bike. I had to extend mine by soldering some extra length.

Bright, easy to install, and would actually work without blinker relay, i already had oone and tuned it to match the tining, so these flash in time with my integrated tail light. Had to seperate the backing plates from the rubber bushings that hold the factory blinkers as these were slightly bigger, but they fit the rubber perfectly and feel solidly attached. Ran them through some rain, no leaks, no condensation, so far so good.

These lights have a lot of potential. They are bright, lightweight, attractive, and have a cool moving pattern. However, they are not robust. The rubber tube popped off the mounting bolt and I had to reattach it with glue. It's really easy to over-tighten these and pull the mounting bolt out. Loctite is a must since you can never tell how tight the nut actually is since there's nothing to tighten the nut against. But hey, they look rad.

Works great but don't forget to get voltage regulators if your motorcycle has led lights. They will not work properly without them.

I can’t complain about the price but I would’ve gladly paid 3x to avoid the frustration. They look fine but the function matches the price. One of the four signals will not properly operate. Of course it was the last one I installed and for the price I’d rather just leave it for the time being than remove the other three for a return. The problem: The signal works when you turn it on, but when you turn it off, it continues to flicker. I disconnected and reconnected with the same problem. I’ve changed many signal kits and have never had one do this.

They work and they are bright enough for daytime use but....The rubber tears easily. The mounting nuts keep working loose. When tightening the loose mounting nuts, the studs pull thru the body very easily. I dont recommend these lights at all.

First, the lights. Decent enough and bright enough for a small light. I know that some people have commented on them not being bright enough but they are just as good as the stock units. Overall, considering price and function, these are great. Here is the problem: Your lights may not flash properly. When switching from incandenscent lights to LED, the lights stay on without blinking. The solution is to use an LED diode kit. Easy to find on Amazon and not expensive and easy to install. I would give these lights 5 stars if they came with the kit.UPDATE: I contacted the company for support to find out why the LEDs would not blink after installation. I still have not heard from them and did my own research and found the solution (diode kit). I am downgrading my rating based on this. There is no support from the supplier.UPDATE #2: The company has contacted me for support and has worked to resolved the problem. These lights are now working fine with the diode kit installed.

他の方のレビューを見たらリレーが不要、抵抗が必要とありますが普通にLED用リレー(点滅速度可変式)に交換して使用しています。明るく点灯するので視認性も良く、流れるのでカッコ良いと思います。点灯面にEマークがありますが点灯している面を見たら車検に必要な7平方センチは無いような気がします。メーカーも車検対応とは掲載していないので、たぶん検査員に「不合格」と言われそうです。ご自分で車検時の対応ができる方ならば安くてアリの製品だと思います。製品の外観も雑なつくりではなくしっかりしており防水も大丈夫そうです。あとは耐久性ですが、こればかりは不明なので…。とりあえず、2年ほど動作すればよいかなくらいの気持ちです。

My order was shipped and revived in a reasonable timeframe. The products was properly packaged for a secure shipment.The turn signals and relays are both really well made for the actual cost of the items. I’m very satisfied with this purchase.I completed this install on my 2018 Triumph Street Triple. Installation will be challenging for individuals with no knowledge of electronics as nither signals of relays comes with instructions for setup. I also had to splice and crimp the plate LED wires to use the bikes OEM harness connector which is nothing out of the ordinary.The end results is absolutely fantastic!... LEDs are super bright.

中のLEDの貼り付け方が少し残業でもモノはこの値段で買えるのは良いと思う。

Nice compact indicators for a fantastic price, I like the sequential light feature but there was no amber marker/running light for the front indicators on the set of 4 that I purchased .