M-D Building Products08462 18 ft. Black Vinyl Replacement Garage Door Bottom Seal

Easy to install if you watch what you are doing. Sliding vinyl into a channel won't be 100% easy. I hope it lasts. Seems to be pretty sturdy.

It sure was a pain to get on, but that's because of my garage door. Once I got this seal on, it was great. Happy with the price.

I was completely amazed! I fully expected this to be a real pain in the butt project. I have 2 nine foot wide metal garage doors so I ordered 2 strips. The order came quickly. The doors still had the original bottom seal on them from 20 years ago. That is, what was left of the seal. The material was torn and what remained had morphed into something hard and brittle. I could not believe that the remains of the old one slid out. Sliding it out did a pretty good job of cleaning the track but I used a small broom to make sure all the remaining debris was gone. I unrolled the new product and draped it over a six foot ladder. This kept the material at about the same height as the partially closed door and reduced the pull against me as I fed the strip into the track. I was surprised at how easy it was to feed the new strip with a simple push and pull motion. The whole process took me about 10 minutes per door. When complete there was about 3 inches of overhang on each end. That was too much and would not allow the door to close without hitting the rail supports. I used one of those cheap (dollar store) plastic razor knives that allow you to push out as much of the blade as you want. This was important because it is a pretty tight space and it allowed me to "saw" my way thru the strip. It took a little try and error to get it right but I ended up leaving about an inch overhang on each end. That seemed to work well. No clue how the product will hold up but I am very pleased at this point. Given the price and ease of installation if I have to redo this work in a few years then I would still be happy.

This weather strip looks heavy duty. I first ordered the smaller spline size, and it kept falling out of the track during installation. The thicker was very difficult install, even though I used a boat load of soapy solution to lube the tracks. It finally was done after about an hour of struggling. Hopefully this will last years

Just like factory garage door seal

Good quality, I measured 2mm thick.

Way better than factory seal. Went on smoothly and fit great!

Perfect fit Fast shipping Thanks

I took my time and it fit perfectly.

Definitely need 2 people to install, one to pull and the other to feed and hold straight. Also needed lots of lube, I used WD40 sprayed on the track and on the rubber itself. Seems to work just fine but haven’t seen it function in rainy weather.

The T section was way too wide to fit in the tracks, the dimensions were not shown in the product description and the seller is not answering any questions. Hence low rating and the product will be returned.

Removed old bottom Garage Door seal (weatherstripping), cleaned track, lubricated track with Silicone Lubricant Spray... With a helper, one to feed the seal on to the tack, and one to work it along the bottom of the door. It took maybe 10 to 15 minutes. This was a Double Garage Door 16 Ft. One corner did show a little light, Worked the seal by running my hand along the length of the seal applying upward pressure. Now it Seals perfectly .

Coupe froid de bonne qualité mais un peu trop étroit, le coupe froid d’origine mesurait 3.5 pouces de large c’est 1 pouce de plus large mais beaucoup plus étanche.