Omix-Ada | 13316.01 | Glove Box Insert | OE Reference: M1093 | Fits 1972-1986 Jeep CJ, Black

nice sturdy plastic, fit into my CJ7 with no problems at all

Nice fit

After replacing the heater core and rebuilding the heater core box, I thought this might a nice finishing touch to my 1979 Jeep CJ7 GE. It fit perfect and was easy to install. Much more rugged than the cardboard glove box that the jeep came with.

Nice thick plastic, fit really well in place and easy to get in place. Only down falt is absolutely no mounting hardware.

Better made than the original Especially after seeing the glove box physically I felt like I got a good value for the money. I did not realize that I would have to remove he dash once again to install it however its a CJ so simple procedure

This is a pretty simple product and not much to go wrong with it.After removing the old cardboard insert, this one slid very easily into place. You do have to squeeze down on it a little but it will definitely fit into the hole without removing any other jeep parts. Once in place, I marked all screw holes with an indelible marker, removed the insert, drilled them out, placed it back in place, and installed all the screws.You may need a stubby screw driver if space is tight (I have the dash grab bar and a full roll cage). I ended up using a Leatherman type multi-tool to screw 2 of them in since that is what I had handy.The inside space does appear to be slightly smaller than the cardboard insert but nothing significant. A reminder, the plastic is very slippery, so items inside will slide around when driving. You can put a tacky drawer liner in there or maybe they can design newer ones with texture to provide some friction to keep things from sliding around as much.Overall, very pleased and would purchase again.

A very sturdy product. Looks far better than the waxed cardboard original.Installation does involve a little massaging. Here are a few hints steps to help you along:Equipment:1. "Stubby" phillips head screwdriver (due to the tight space this makes things far simpler; otherwise you may want to remove the dash handle/grab bar).2. Drill and bit set.3. New glove box insert. (plastic; includes 6 self-tapping screws)Installation steps:1. Remove the glove box latch bracket (2 screws down from above; keep these screws).2. Remove the old glove box insert (can be up to 6 screws).3. Insert the new glove box insert (requires some gentle nudging, just be sure to clear any wires and carefully work the new insert in by angling back beyond the metal flanges which held the original insert screws, then push the insert from below the dash over the screw flanges and all should be snug)4. Mark the holes on the insert.5. Remove the insert.6. Drill out the 6 holes on the glove box insert.7. Re-insert the glove box insert.8. Install 6 screws.9. Replace glove box latch bracket.10. DoneAlternatively, steps 4-7 can be skipped using a socket tool. or by using the original glove box insert to mark the holes on the new box (if yours is still intact) before the first installation. I found it simpler to pre-drill the holes, as the plastic insert tends to bend and shift under the stress while driving in the self-tapping screws.

won't hold much too shallow