ZXMOTO13Ft Headlight Sealant Retrofit Refit Butyl Rope Rubber Glue Reseal for Car Headlamps Window Door Windshield (1 Piece)

It fixed my car, easy to work and super sticky.

Used this to reseal my headlights I rebuilt with new lenses. Longest part was cleaning off the old glue from the housing. Baked them @215 for roughly 7-10 min. Checked and pressed the lens on further and put it in for another 5 min or so. A month later no issues, no moisture and is holding up well.

Used to install led projectors and added this sealant to prevent leaks. Works has been raining a lot recently and no humidity in headlights.

I got new plastic lenses for my headlights and used this sealant to seal them up. While the sealant itself worked great, the packaging could have been better. It arrived smashed in many spots and was no longer in a consistent bead. The paper tape that its wrapped in is also of poor quality and tends to tear off in little pieces rather than cleanly separating in one piece. Other than that I am very satisfied. I was able to seal both of my headlights and I still have half of the roll left.

My first time taking apart a headlight and this sealant made reassembly a breeze. So far absolutely no leaks

This works great if you make sure to remove the previously existing sealant already in place on the headlights. After you do that place this in place and use a heat gun for about 5 minutes from a good distance away and without keeping the gun on one spot for very long. This should heat it up enough to make it nice and sticky or you can then press it together with the headlight housing. Once you do this use some clamps to clamp down the headlight lens and the housing together in at least four different spots and let it sit for a few hours. If you want to speed it up a little bit wait a little while at least, then use some compressed air and turn the can upside down and spray it on the sealant. It will harden it pretty quickly but make sure to at least let it sit for a little while before you do this.

Facil de usar ademas sella muy bien las use para poner unos focos de un carro y sellaron muy bien

This was just ok, I still needed rtv after adding this and even hitting it with a heat gun to make it more pliable to prevent water condensation