30A 250VAC/35A 125VAC KCD2 KCD4 Rocker Switch DPST 4 Pin Red Lighted 120V Rocker Toggle Switch ON Off Heavy Duty 4Pack

You know those giant inflatable slides? We purchased one a couple years ago and it has worked flawlessly. That is, until my wife ran over the power cable to the fan the other day. When I opened it up to fix the wire, I noticed that it had pulled one of the connectors out of the original switch. See where I'm going? Yep, got this in, swapped it out and was back to wasting electricity in NO TIME! And bonus,..I didn't even realize it was a 4 pack?! I've still got three more of these.

These were a direct replacement and fit perfect. Works great.

This is a decent DPST switch. However, you cannot wire it conventionally using the center terminals as the supply and the outside terminals as the load as you would with a DPDT switch. If you do, the light in the switch will be on as long as the power is on. You have to wire the switch in "reverse" for the light to energize when the switch is turned on. I agree with other reviewers who have said there needs to be a wiring diagram to indicate how to wire the switch so the light activates when the switch is turned on. It seems rather careless of the seller to leave out this important detail in both the images, description and other promotional material associated with the switch. In addition, the product comes in a box with 4 switches although this important detail is also given short shrift by the seller. Yes, it's in the AD title but there should be an image showing the open box with the 4 switches because that's where the buyer will look to see what they are getting. I ordered 2 units, thinking that this was 2 switches. I got 2 boxes for a total of eight switches. Guess I shouldn't complain because I'll never need to order this switch again as I now have enough to last me the rest of my natural life. Good product - bad advertising.

This $2 switch saved us several hundred in electrician/technician bills and put our church kitchen back into operation. They worked great, were just like the original and now almost 9 months later are still doing great. If they fail I'll order another the same day.

Perfect lighted double pole single throw switch. Works perfectly on my heat press when wired identically like the original. Make sure you measure the hole it's being installed in. Mine measured precisely what the listing called for and it was a very tight fit, which pleased me. A hole any smaller would have to be enlarged to accept this switch.

This Switch is pretty heavy duty for what I used it for, but it works

Well, it wires like a 2 wire plug. You use Line and Neutral. No ground.

Works like it should. Product was exactly as advertised.

Greate replacement switch, has 35 ans 30 amp settings, depending on which voltage you are using.