Oudtinx CNC Spoilboard Surfacing Router Bits, 1/2 inch Shank 2 inch Cutting Diameter, Slab Flattening Router Bit Planing Bit Wood Milling Cutter Planer Woodworking Tool 4 wings

Works great in cordless drill as well as milling machine.Used the reduce height of old post in ground.

Not sure on longevity but surfaced a table top i had made no problem

Nice one

Bought this to flatten an slice of English Elm 80cm by 30cm. Did both sides with no trouble. Looks like it is dulling a bit now but still works.Can’t complain for the price.

Paint can be seen in the largest chip so this was before the grinding process. There are also smaller imperfections on 3 of the other cutting edges.I'll wait and see how long it lasts but might be fine for roughing out.

bought this to replace some old worn bits I was reluctant to replace for the cost of them.. but I found this and am very pleased with the quality and sharpness this has, very well balanced so no viberations noticed. overall it functions as i hoped.

I make cedar grilling planks to sell at craft fairs. It took forever in the past to route a 1/4" deep pocket in the wood with a smaller router bit. This spoilboard surfacing bit cut soft western red cedar extremely well & quickly without much tear out. For such a low price it probably isn't C3 carbide, but so far I'm satisfied with it.

Hey it works, for the price that is a good start. I used it for two days and it finally started to dull out, but given the price I was very happy with it' performance.

Works well, leaving a smooth and level surface.