DERNORD240V 5500W Tri-clamp Ripple Heating Element Stainless Steel Immersion Water Heater with 3-Wire Electrical Locking Plug (1.5 Inch Tri clamp)

I changed from the wired elements as this is easier to disconnect just by unplugging and then removing and the cord doesn't have to be dragged with it to clean in the sink. I got the 2 inch version and it works great. For some reason I get less gunk on these elements and the stuff doesn't seem to stick to them as much as the other ones I replaced. I put a silicone O-ring over the prongs and when you plug in the cord the O-ring fills the small gap where the connection is made, so if water somehow gets near this it won't get into the connection. I really like mine and I would buy these again.

I bought 4 of these for a commercial brew kettle (4 BBL) and so far they are working great. Easy to install!

Good

Works perfect for my 1.5in triclamp for my mash ton/kettle. This allows me to boil water much faster than my old 120v setup. Easy to clean with a little bit of steel wool, doesnt hurt the element at all. I'll buy again if I need another.

Decent element and the built in potting and plug is handy. However, the prongs are crude and sharp and arrived bent. I straightened them and had to file the edges smooth from the stamping flash. Have not used it yet in action so cannot report on reliability.

Just ran it with my InkBird and 40DA worked perfet. George at Barley and Hops gave me this 240 idea on one of his you tube videos. He explains how to use this stuff. cant go wrong with DERNORD

We use this product on our three barrel brewhouse. We have brewed with this element about eight times now and it has remained in better shape than the units that originally came with the uni we use this product on our three barrel brewhouse. We have brewed with this element about eight times now and it has remained in better shape than the units that originally came with the system. Also the nine or $10 plug that is recommended works very well too. Much better than spending $40 a plug at the local hardware store. I recommend for people seeking a like use “.

I used the 6500W element in a boiler with a 7500W rated receptacle, and the element began to melt at the plug after several (uneventful) uses. I'm lucky to have been around while it began to smoke, or it could have burned my house down!I have contacted DERNORD to replace this unit for a lower power element as I am not confident in the safety of the 6500W one.

Worked good both times I used it maybe too good, was a bit much for my application.

I use these heating elements for brewing beer. In the past I purchased similar elements from Chinese suppliers that did not have the three prong plug. They work too but you have to make a unction box and seal them so that they don't short out. The Dernord three prong connects make it a lot simpler, albeit at a cost.

Get my mash going real fast makes very good spirits fast really glad I got a 5500 thanks guys speedy delivery from Amazon thumbs up keep up the good work

Ordered this element to go electric from natural gas brewing. Punched a hole in my pot and bought a controller. Heated 6 gallons (24 ish litres) from 8C to 50C in 15 minutes. Delivery was fast. First electric brew day tomorrow.

Finally got the right one but no cover for wires nice safety features. Thanks