Art3d 5-Pack of 24×36" PET/Plexiglass Sheets, Transparent Clear Flexible Plastic Sheet Panels for Craft, Picture Frames, Sign Blank, DIY Display Project

We used these to make a table seating sign for an event. It worked out great and when we had a last minute change it was easy to pull the seating card off and replace it with a corrected one. We were able to drill holes into the corners easily using painters tape and they did not crack or splinter. We used ribbon and twine to hang them. They are crystal clear and come with a protective film and packaged well.

Mine came nicely packed and protected in a cardboard box with some sort of plastic corners to protect the sheets. They are covered in a translucent film on both sides, but it peels off easily, when you try. It doesn't fall off. I'm using mine to make water rails for a set of floats for my RC plane (1.7m Super Timber). I have painted one side of the plastic with spray paint that has acetone as its solvent. No problem for the plastic. I did my rough cuts using scissors, and then did final cuts using my scrolling saw with a fine blade. No problems with either cut. I used some 150 grit sand paper to clean up the edges and make them smooth, and more presentable. Sheets are not brittle, at least not so far.

As advertised! I used this to restore my arcade 1 up plastic protector for the buttons/joysticks panel. Comes with plastic film layer on both sides, helpful for marking measurements. FYI, these were slightly thicker than the originals, but still worked. Workable with jigsaw and hole saws.

Don’t usually do product reviews but this worked really well. Not sure of folks that had a difficult time cutting this because it was very easy for the 70+ year old to cut with scissors. My husband drill holes in the corners and I used small zip ties to hold it in place. I’ll attach a picture but quite honestly, unless you zoom in, you can’t even see the clear sheets. Of course time will tell and I’m sure they will need to be removed and replaced with some time because well, the bird is messy. That’s why we bought these in the first place. Hope this helps.

This plexiglass seems to scratch up very easily. But I guess for the price it’s a good deal. You can use one of these on top of your desk, to protect it. I guess some people use it for their windows, or other stuff.

Easy to cut with a fresh utility knife blade. Remove film on both sides.Great for picture frames, new or replacement.

The media could not be loaded. These worked great for wedding signs - that said, apparently I was not paying attention to the size, because they were WAY bigger than what I thought I ordered - which worked out because the flower garlands I bought would have looked strange if they were smaller. These are flexible but not flimsy and with some creative use of my Silhouette and some glossy vinyl, I am pretty happy with how they came out. (IGNORE THE MESSY KITCHEN - My office is getting new flooring so all my craft supplies are fighting for their life in my kitchen).

We used this with low profile thin velcro tape strips on the sliding glass door screen to protect it from our cat shredding the screen. It was easy to cut with scissors and is clear. Worked perfectly.