SPTA 8" (200mm) Wool Buffing Pad, Double Side 100% Natural Wool Pad with 5/8-11 Thread for 2-Sided Compound Cutting and Polishing for Automotive, Marine and Epoxies

Great product good for buffing boats and holds up great over use

Excellent high quality wool buffing pad for compounding and buffing. Minimal wear after initial fluff is gone. Can't beat the threaded center.

I really like these pads a lot just enough, given them to go around corners and in between body lines

The SPTA 8" Double Sided Wool Buffing Pad is a good pad for the price! I use it to buff boats with my Dewalt buffer with heavy cut compound as my first step to remove oxidation and scratches. It cuts efficiently and is durable. It will shed a lot during the first run though. Its seems like a lot but it really isnt and you dont notice any missing wool from the pad. I can buy two of these pads for every Lake Country or about three for every 3M pad. The shedding is annoying but if you can bare it may be worth giving it a try. They're also good for a secondary pad if you dont want to mess up a good high end pad on something you can switch from one to the other.

1.) Hole depth Pad to Pad = .629" (5/8”) or (15.98mm) 2.) Metal part of threads only depth .394" (3/8”) or (10mm) 3.) Pad thickness lying flat 3" or (76.2mm) 4.) The pad width 9.5" inches to fiber edge to fiber edge, 8.5" not considering the fibers. 5.) The length of the strands of wool = 1.436" (1- 7/16”) or (36.49mm). (Seems a little too long) <1> The wool threads are looped to a thin padding which is on and around the disk which has the threaded attachment hole. Measuring from top to bottom of that thin padding gave me a depth measurement of #1 seen above. <2> Not counting the thin padding mentioned in the paragraph (<1>) above, the depth of the metal threaded part only measures as shown in #2 above. <3> Laying the "new" pad flat on a table, the thickness of the pad measures 3" in height <4> The width of the whole buffer pad new, is 9.5" inches to fiber to fiber. Feeling inside until I feel the disk which the fivers are attached, the width is 8.5" inches. Noted in #4 above. I have not used this pad yet as I need to get an extension for it. However, the quality seems pretty good. The "strands per inch" or "threads per inch" is pretty tight making it seem pretty dense. I think it will last a long time for me using many different materials on it. I will be using a flat-head screwdriver on the pad while it's spinning to clean it. This type of cleaning (when dry) works great as I used to do this professionally. My Buffer's Arbor length = .79" (13/16”) or (20mm) - I will need to get an extension for my arbor to push the pad away from the buffer housing and to shorten the threaded end of the arbor to 10-15MM in length so it doesn't stick out the other side of the pad and cut through the paint. Photos show my arbor screwing too deep through the pad that is why I need an extension. Also, the pad is against my buffer housing and must be pushed back some. If my opinion changes from the above, I will come back and adjust this review. This initial review was left 12/28/2024.

Muy útil

Excellent quality, I've ordered it several times.

nice thick pad both sides

Excelente relación calidad y precio

Commencer à polir ma mustang sa fais une super de belle job bien contant

Elle estdetruite au premier utilisation