BIQU Flexible Steel Removable Platform with PEI and Magnetic Bottom Heated Bed Build Surface 310x310mm for Creality CR 10 3D Printer

I bought the BIQUU SSS kit when they first launched it direct from them.New sheet is much thinner than launch, but works great!But.. if you have a magnet on your bed already and you know it works, leave it, im so glad I never removed mine and put new one on, IT DOES NOT STICK the sheet down, it slides everywhere, I tested with my old SSS sheet and the same, wish I had bought the SSS sheet only, i'll keep the magnet just incase.

I used this to replace a trashed plate on my ender 3 v2 neo. I've done several days of printing so far on it, adhesion is good once its up to 60-70c for PLA and once it cools prints just pop off. Early days yet but impressed with this build surface so far.

I installed it on my Elegoo Neptune 2 (after I managed to tear up a bit of the original print surface), re-adjusted my bed level settings, and it worked straight away. Much better adhesion than the original surface, and much easier to remove finished prints. A great replacement, I can definitely recommend it.

Works perfect. Perfect bed adhesion...

lots of issues with adhesion to this plate ,

I really like this build plate. Much better than the original that came with my ender 3 S1 plus. It’s double sided too. I’ll definitely buy this again.It’s true you get a slight orange peel effect on the base of your prints, like a bad paint job on a car but I don’t dislike it either.

This steel bed is a lot more flexible than the one that came with my Creality Ender 5 S1. However, the magnets work and is sticks to the heater plate with no issues.I did a quick manual bed level on the corners, adjusted the Z axis offset and set it printing. Adhesion appears good, so looks very promising.This plate does not have locating notches (unique to the Ender 5 S1), but that is a non-issue. Time will tell how long the surface lasts, but it is double sidedAll in all, a good replacement if you damage the bed that came with your printer. Cheap, good adhesion and the flexibility makes removing your prints easier.

For best results use along side the cheapest nastiest 70s style hair spray you can find. The stuff that if you had enough hair you could spray it and not need a crash helmet. The board itself is quality and hard wearing. But nothing sticks to it without it being seasoned after that print amd forget