6033 Universal Rotisserie Kit

I had to drill a couple of holes for the brackets. I knew when I ordered it I would have to do this.

I purchased a Sam's club Member's Mark Pro Series 5 burner grill. It is larger than my previous Member's mark grill and my old rotisserie did not fit. I had trouble fitting my previous grill because universal brackets didn't match up to the holes on the grill and I had to modify the brackets to make it work. I expected the same with this grill so I checked Sam's. They do offer a rotisserie for this grill, but they have been out of stock for a while now. I saw another review mention Sam's, so I tried this one, and it fits just fine, and works well. However, I did need longer screws.

Should have been a five star but my motor ran counter clock wise looking at the drive end. Which results in the shaft unscewing. If you are "qualified" you can open the motor up and a wiring diagram is inside. It shows the red wire hooked up to the ccw side of the capacitor. The other side marked cw would be the correct side for clock wise direction keeping the shafts tight.

used on Pit Boss 1100 Pro doutble oven. comes with 2 set of tines and everything needed to install on any gas, propane, wood pellet grills works. Would absolutely buy again and recommend

Don’t buy it. ITS NOT STAINLESS STILL, something like aluminum came off when I cleaned!!!

Me. Sirvió para un horno cassero y para mi barbacoa en casa por eso lo recomiendo …..

As described, easy to assemble, works fime

I am very happy with the product. Purchased a returned item from Amazon. It was in the original packaging but obviously it had been opened. Inside were all parts except for the hardware (nuts & bolts). There was a plastic bag, but it unsealed and empty. The motor mount is pre-threaded so you need the right size screws (4 x M4*6). Fortunately I had all the hardware in the shop, so no trip to the store.Just finished cooking a small turkey. Five minute before I was ready to pull it off the BBQ, the rod came apart, dropping the turkey into the coals. Poor design - the motor turns counter-clockwise which means the rod should have left-hand threads. When the motor turns it should tighten the pieces, not unscrew them.