Jonard ToolsWBK-100 Panel Buddy Knockout Set for Front and Rear Knockouts

Actually works. I was skeptical when I ordered it but it was surprisingly easy to remove knockdown from electrical box.

This went far beyond my expectations. It really works

I had to pop a knockout out in a panel in a tight spot, where I would otherwise cut a low voltage plate in, and and hammer the knockout out. I had a case, where I did not have clearance to do so. I used this on a Hubbell Network Enclosure panel in drywall, which barely had a gap around it. I had to jab a bigger gap, but the panel surround/door covered it right up. The tool worked without a hitch, and was almost easier than hammering the knockout out. I'd highly recommend this tool!

Works great!

After using the product for the first time, I was absolutely delighted. It made opening the knockout to a panel in a finished wall so easy. Wish I had gotten one years ago.

I used this tool two to three times a day for two years before I finally broke it. It didn’t always work but that’s because some of those older panels are real thick and barely stamped. Still gave it a good heavy go though. You also might have to patch a little drywall that ends up behind most covers anyways. All my coworkers are jealous of it. And since mine broke I’m buying another.

Great Idea and I made my own......Except I still had to cut the dry wall to put in the clamp for the wire.

I am an electrician and was a little skeptical about this product. However I have now used it in the field and it works like a charm. Its a very clever device. Its also sturdy and well made.

Great product

Works well, just need to be carefull using it