Downcut Spiral Flush Trim Router Bit, 1/4 Inch Shank Solid Carbide Flush Cut Spiral Router Bits with Nano Coated by Tackpro (Router Bits 1/4 Shank Down-Cut)

Does the job

The first time this but touched a piece of wood it snapped in half. Didn't even start to cut.

Initially, a single mild practice pattern cut through 1/4" MDF, I found this bit flawless and the performance second to only a compression bit.Just yesterday, 7/27/23, I found myself setting up to copy a hardwood panel to make a template for my childs vintage chest of drawers. With no more than an 1/8" of material to CV ut through, the bit sheared cleanly at the termination of the flutes to the solid stock.I used the same Makita trim router as before, but when initial contact was made, the single bit was mow two pieces.Damn shame. I'm now in the market for a different seller/manufacturer. I cannot recommend this to anyone.

We do laminate over wood and the bit did not last very long at all compared to others that are not spiral.I was hoping but not impressed by the product.

Snapped in half at first cut

The bit it's sharp but the bearing are garbage they fall apart like in 60 feet of cutting 7/16 osb and after that it's rough to cut anything

very bad quality bearings fall off with minimal use.

Bearings flew off the first-time I used it waste of money

Works great

Broke within 10 seconds. Waste of 50$ I didn’t really want to spend