THE CIMPLE CO Dual Cable Clips, 100 PCS, Indoor/Outdoor Cord Management, 1/2 in Wire Clips for Coax, Ethernet, Electrical Wire, Screw Clips for Wires on Wall, Black

The work perfectly and look great

I bought these to install into my basement walls to hold cables flat. They do the job well and can fit a romex cable easily. It goes in easily enough on wood but if you’re putting these in concrete/cinderblock you’ll need to predrill and use an anchor for them to work well.

Just as expected.Cable opening might be too large to properly clamp new, thinner style cat6 cables.

Solid cable clip. Just worth noting, the screws were slightly too short to reach the wood studs behind my plaster board, so ended up buying other screws. It would be better if they offered these with 3/4 or 1 inch screws for that type of application.

I have used a lot of different cable clips over the years, and these are the best for coaxial cable and 12-2 and 14-2 romex.The screws are quality and don't strip out.The plastic is thick and doesn't snap.Attach them loose and cable slides right through. Cinch them up tight and its not going anywhere.Buy the big pack - you're going to want them.

Use for ethernet installation

I installed Cat6 cables for my surveillance system in my home. I purchased a bag of 100 clips and it made the cable management a lot easier and neater. Good strong clips and it really helps to use a magnetic nut driver bit attached to a drill I highly recommend these clips.

I grabbed these to attach a coax and cat 6 run to the side of my foundation. I went ahead and got it all installed, using a 1/8" pilot hole due to that being the smallest size bit available for concrete. During install I had several of the screws break. Once they were installed I left them then checked on them the next day. Several had pulled out of the cement. To rectify the situation I went out and bought some 3/16" by 2-1/4" Tapcon screws. I removed the provided screws and installed the Tapcons in the holders then used the 5/16" Tapcon bit to create pilot holes for them screws. The combination works quite well. The screws are fully embedded and are not showing any signs of pulling out and none of them broke.