Electronics-Salon Low Voltage Disconnect Module LVD, 24V 30A, Protect/Prolong Battery Life.
Thumbnail 1Thumbnail 2Thumbnail 3Thumbnail 4Thumbnail 5Thumbnail 6Thumbnail 7

Electronics-Salon Low Voltage Disconnect Module LVD, 24V 30A, Protect/Prolong Battery Life.

4.2/5
Product ID: 38562545
Secure Transaction
⚡30A high current rating
🔋24V battery compatibility
🛠️Panel mount design

Description

🔋 Protect your power, prolong your performance!

  • MAXIMIZE BATTERY LIFESPAN - Automatically disconnects low voltage to protect your 24V battery from deep discharge.
  • ESSENTIAL POWER MANAGEMENT - A must-have for any serious professional looking to safeguard their power systems.
  • ROBUST 30 A CURRENT HANDLING - Handles up to 30 amps, ensuring reliable performance under demanding loads.
  • SLEEK PANEL MOUNT INTEGRATION - Designed for seamless panel mounting, keeping your setup clean and professional.
  • VERSION 2 0 ENHANCED RELIABILITY - Upgraded firmware and hardware since 2017 for improved durability and precision.

The Electronics-Salon Low Voltage Disconnect Module (MD-D1021/24V, Version 2.0) is a panel-mount device designed to protect 24V battery systems by disconnecting loads at low voltage thresholds. Rated for 30A current, it ensures reliable power management and extends battery life, making it an essential component for professional-grade electrical setups.

Reviews

4.2

All from verified purchases

N**F

Solder high current 'traces', pic

I ordered this to do LVD for a mower that pulls 20-30 amps. I haven't tested it yet. Here is a cropped pic of the high current carrying pooled solder. One area towards the left contact looks narrow/weak. Any bets? Adding this pic because the seller did not include one of the backside.Update: I ran it for a half-hour without a failure. Grass wasn't long enough yet to push towards 30amps, however. Bumped up 1 star since it didn't fail right off.Update2: After several more uses it is holding up, but still haven't had/made opportunity to load it right up to 30A continuous.Update3: Unit made it through weekly usage through the whole season and Fall cleanup. Calling it good.

J**Y

Excellent for protecting my electric mower batteries from my kids.

My kids frequently use my older electric mower with SLA batteries. Despite my adding an LED to indicate when to stop mowing due to battery state, they are accustomed to gas mowers and sometimes take my batteries to near 100% discharge. Adding the LVD, which is much cheaper than even SLA batteries, allows me to "enforce" my instructions on when to stop mowing. Easy to use. Easier if you have a wiring schematic of your device.

M**K

Easy to install

I have made reviews on this before. It works well.

4**E

Works as specified, but product could be designed better.

It works OK and as specified. I just wish it had more voltages selections than it has for the cut-off and reconnect. At 24.2 and 25.6 you are cutting out after you have drained below 50% and reconnecting at greater than 100% charge. If you use any other set of switches on the cut out side you may be damaging your battery by excessive drain. By 20 volts the lowest cut off your batteries are basically at 0%. Not good for lead acids. I installed a large diode in series with this with a forward voltage drop of 0.6 Volts so that cut off happens closer to 75% of battery life.

I**E

Inexpensive and reliable battery saver

I have used the 12V version for a year, and the 24V version as of a month ago, on small off-grid solar + battery systems. Straightforward to install and configure, and no failures so far. LED provides easy feedback on status of circuit (green when enabled, red when disconnected. Recommend using standoffs when mounting since there are components on both sides of the PCB, and mounting in vertical position to support air flow across components.

N**1

It Just Woks!!

Great alternative to having a BMS which you cannot test and check for accuracy on the bottom end of charge cycle. this product just works. Install this unit in between the lithium battery and the load/charge and you are basically done. Unit will disconnect once the battery reaches the specified low voltage and cuts the current so you cannot damage the battery. Great Idea and it works great.

C**S

Very good battery protection

Used it as over discharge protection for a lithium ion battery. Works very well.

M**S

Works as expected

Works as expected. Automatically shuts off at the selected voltage.

Common Questions

Trustpilot

TrustScore 4.5 | 7,300+ reviews

Vikram D.

The MOLLE sheath is of exceptional quality. Very happy with my purchase.

2 weeks ago

Anjali K.

The product quality is outstanding. Exactly what I needed for my work.

1 month ago

Shop Global, Save with Desertcart
Value for Money
Competitive prices on a vast range of products
Shop Globally
Serving over 300 million shoppers across more than 200 countries
Enhanced Protection
Trusted payment options loved by worldwide shoppers
Customer Assurance
Trusted payment options loved by worldwide shoppers.
Desertcart App
Shop on the go, anytime, anywhere.
€ 32.97

Duties & taxes incl.

Irelandstore
1
Free Returns

30 daysfor PRO membership users

15 dayswithout membership

Secure Transaction

Trustpilot

TrustScore 4.5 | 7,300+ reviews

Ravi S.

I loved the variety of products available. Will definitely shop again.

2 months ago

Suresh K.

Very impressed with the quality and fast delivery. Will shop here again.

4 days ago

Electronics Salon Low Voltage Disconnect Module Lvd 24v 30a Protect | Desertcart Ireland