TRUE MODS 4pc 6 Inch Red Oval LED Trailer Tail Light Kit [Stop Turn Tail] [DOT FMVSS 108 SAE S2TSI6P2] [Grommet & 3 Prong Plug] [IP67 Waterproof] Trailer Brake Light for Boat Trailer RV Flat bed Truck

Initially I was going to buy another brand. After seeing the amazing reviews on this brand, I chose these. I just received them 30 minutes ago. They have been completely installed and functioning perfectly. They were a perfect fit. Plug and play and easy to install. They are nice and bright, and the quality is excellent. They have exceeded my expectations. I would give them 5 stars and happily recommend them and purchase them again.

Needed to replace my old trailer lights for my Triton trailer. Perfect fit and takes maybe 30 seconds to install.

These are bright and work well!

I haven't installed them yet but they look to be good quality and good information on how to install them. Will update after installation the seller had them shipped quickly and for that I'll be a repet customer provided they work as well as the add. The wirer sise is what I would expect from it to be the size looks great for fitment

These LED light lit up the back of my boat trailer like you wouldn't believe! way brighter than the old lights of yesteryear.

I recently refurbished a utility trailer, including all new wiring and LED lights. After searching several sources, these oval LED's seemed to be the best value out there. They are nice and bright, look sharp, and include industry standard connectors. Overall, I'm very happy with these lights. You get two lights for the price most places want for just one. Some reviews mentioned that the light fits loose when mounted and had concerns of it falling out. Mine seemed to fit pretty well if you install it properly, but just be safe, here's a pro tip: Coat the mating surfaces of the rubber gasket in a healthy bead of clear silicone caulk. This will secure it in place but also allow for easy removal in the future if needed. I used silicone on both the rubber gasket to trailer, and the gasket to the actual light. They are in nice and solid.

I replaced my boat trailer's leaking Truck-Lite 60 series incandescent lights with these LED lights. The housing of the new lights was the same size as the old lights but the rubber grommet that came with the lights was much thinner and flimsier then the Truck-Lite grommet. I tossed out the new grommets and reused the 40 year old Truck-lite grommets. These lights fit perfectly into that. When I tried using the grommets that came with these lights the new lights just fell out they were so loose. The wiring connector used with the new lights was very similar to the Truck-Lite connector but the pins are offset with different spacing. It would have made the installation so much easier if I could have reused the original wiring connectors. I had to cut the old connectors off and wire the new ones on. This was not a big deal but a lot more work than necessary. Truck-Lites are pretty much an industry standard. I'm happy with the brightness of the new lights. I'll have to wait and see if they hold up for 40 years like the originals did.

These lights came in and I was anxious to install them and make sure they worked without making changes like adding resistors to make them flash. I also had some concern about the size being correct. These lights came with the pigtail for the wiring, as well as the boot that holds them in place. So the size matched my old ones and worked with the old boot. The new boots were not as heavy as the previous ones, but still held the light in securely. As I went to plug them in I wanted to add some dielectric grease, but this was already there, just pealed off some tape. Then it was time to plug them into the truck and try them out - they worked great as direct replacement to the standard bulbs. So I just installed them and cannot attest to how long they will work, but I can can say they went in quick and easy, look good and work great. Time to try some backup lights.