Attwood Corporation 2027-7 ABS Flush Hatch Pull

Very well made. I do wish hardware came with it that matched the handle. This is much better then the single ring that I replaced with it. I hope that it lasts.

Great little handles. They work well, dont know how well they hold up to long sun exposure, only time will tell, but they seem well made.

Did the job no issue we its been on the boat for a while and it hasn't shown any signs of breaking or wearing out.

Bought these to use in hatches I'm building into a deck on a Jon boat. They are a good size for a 3-4 finger pull depending how big your hands are. They seem to be good quality.Only issue is with the mold flashing. It leaves a sharp edge along the entire inner edge of the hole for the pull. I took a few minutes on each with a deburring tool, razor knife, and sand paper to eliminate it. I have small kids that I'm sure will be pulling on these and also didn't want to chance skinning my wet fingers while out fishing. Considering the application and intended usage this is a significant shortfall that should be taken care of during manufacturing. See photos for a pull with flashing and one I fixed.Will update when I have them installed.

Purchased these to replace original pulls on 20 year old boat. Exact replacement. Good material, well made.

Exactly what I was looking for. Seems to be pretty durable plastic and I feel like they will last awhile.

just what I wanted/expected

This is just what we needed to make it easier to get into our crawl space. I know it's usually a boat item, but it worked perfectly on the hatch to our crawl space too!

99% same as stock handle which broke. Holes were slightly off, no big deal. Would recommend as a good replacement handle.

The hatch pull worked well although some modifications were necessary due to it’s size compared to the original.

Works good

Ok

This is a nice handle for a compartment lid, not sure if the UV rays from the sun will affect this material.I guess time will tell.