Strong Hand Tools, Nomad, Steel Welding Table, Three 1.1″ (28mm) Tabletop Slots, Adjustable Angle & Height, Casters, Retractable Guide Rails, Eccentric Leveling Foot, TS3020, Black

Hobby welder here, this table is nice! Definitely worth having around.

al armar las patas y pararlo no queda completamente soportado en el suelo y se mueve, esto se pude resolver de alguna manera al continuar el ensamblado o es defecto de las patas?quedo atento a sus comentarios e indicaciones

Good value for the money I would’ve used 8 mm³ wing Nutz instead of screw plates to secure the bench tilt mechanism

I needed a welding table I can stow in the garage, but place outside on the driveway when welding. The Strong Hand Tools, Nomad, Steel Welding Table worked out well. Table angle is adjustable as is height and it all locks up without wobble.The rear legs have caster that touch the ground when the table is pulled along. The front legs have eccentrics that rotate to level of table on an uneven surface. No tools are required for set up or take down.The frame is powder coated and does not easily scratched. The heavy gauge table top is protected with yellow zinc plating.Two reasons for the 4 rather than 5 star rating. The assembly instructions, particularly illustrations are not great, however, it is a simple assembly so a picture of the table should be enough for most. Pieces are not tagged, but hardware is carefully packaged and complete.The second is more of a workmanship issue. There are pass though safety locks (chrome U shaped locks in the picture) that prevent the table from lowering under weight. The locating holes on one leg were punch cleanly on one side, but not the the other, so the safety lock would not pass through. I cleaned up the blocked holes with a drill and the locks worked as intended. Five minutes of work and the table is too good to return for a minor fix.

I've been researching all these portable welding tables, reading lots of reviews. Settled on this one. Took about 40 min to assemble. Parts seem quality and not cheap. I'm no professional fabricator or even decent at mig welding yet. Prior to buying this table I was welding things on the floor of the garage or standing at a bench vise.Purchased some accessories for it and tried out some test pieces. Table is sturdy. All in all I think it was money well spent.For those leaving negative reviews about quality are expecting too much and are too cheap to spend money on a nice fixture/welding table.