KIPA Front Wheel Axle Hardware Kit Replacement For John Deere M143338 GX21931 R27434 Z9972H M123254 Hub Caps Thrust Washers E-Clips pack-4

My low rating isn’t because of a quality issue, they seem to be of sufficient quality, the issue is they don’t fit, not even a little. I’m keeping them because I do want an extra set of washers and clips on hand after spending an hour searching in the grass and dirt for one of my clips last time Zi took the wheels off, the washers do fit. The whole reason I ordered this however was for the bearing caps. The bearing caps are not even a little useable on my D130 (which is listed here as supposedly fitting), the caps are way too big, they just fall off sitting there. I can’t imagine what they would fit on since most John Deeres have 3/4” axles like mine, heavier duty models have a 1” axle which I imagine these rubber covers would be too small for. You can’t even get them kind of staying on, they literally just fall right off, not happy at all.I should also point out the washers are also different specks than original, the inside hole is fine so you can use them, however the outside diameter is considerably smaller and they’re about twice as thick as the originals. If you don’t have a little play when you put the clips on you won’t be able to use these because the thicker washers will push your wheel on the axle out past the slot to put the clips in, I had to actually sand down (no big deal) the length of my spacer tubes to use these washers.

My low rating is due to the quantity count of the kit washers. Should have included 6 total of the smaller washers but received 3. To make this kit useful I need to purchase additional count or start stripping the worn JD wheel washers from the trash. Dissatisfied that quality control was not implemented to just perform a simple volume count before packing this kit. Made in China was not good. Certainly not worth the effort to return this kit for another replacement.