HiLetgo 2pcs NRF24L01+PA+LNA Wireless Transceiver RF Transceiver Module with SMA Antenna 2.4G 1100m

Garage doors will never be safe again. The connectivity and value for the money makes this a must have for all raiders. Not to forget the build quality being top tier.

The media could not be loaded. Using a pair of HiLetGo nRF24L01 transceivers, have coded a way to switch a battery remotely, put the ESP32 to deep sleep and wake-up using external 0, RTC_GPIO, and power up/power down the transceivers.Have coded a way to accomplish task of remotely switching a battery, switching is by Async web server request. Request “control” variable, determine on/off option. “Control” variable selects one of two options. Each option has three tasks: task one, switches battery power, task two switches transceiver power mode, task three switches deep sleep state. Have not “field” tested project; tested with two multi-meter monitoring current of transceiver bus (only a pair of nRF24L01’s) checking voltages with the other multi-meter. Performs functions as coded; works well.Project is a work in progress.Pair of nRF24L01 current draw; transmitting is 30.4 mA in non-standby mode, 6.6 mA in Standby I mode measured with multi-meter. Transmissions will only be a very small fraction of a second.Couple of recommendations; identify ground pin using a multi-meter, purchase a nRF24L01 piggyback voltage adapter; allows use of five-volt power. Some boards have trouble supplying required transceiver current. Do not let early failures stop your project or ask to return defective transceivers. Fully explore reasons for failures. Mine turned out to be coding errors. If the code is not allowing transceiver to exchange data, check your code! Fault hardware last!

The noise is a little higher than I thought it would be but very useful for long distance off-grid communication. They are well built and will last me for a long time. It can be a little complicated to figure out how to use it but after some YouTube videos you will be up and running in no time.

One worked great. The other has a short between GND and MOSI. I build similar chips. Thusfar; I have been unable to find the short.

Worked great with the flipper zero once properly soldered

One worked fine, the other was junk. Really disappointing.

If you prefer to avoid tinkering this might not be the device for you however, After a bit of time and lots of testing I was able to get these to work between a pico zero and a nano. Side note these also need their own 3.3v power supply or regulator. Overall testing it works fantastically and through walls and at quite the distance.

I may have received 2 faulty transceivers, but neither of the ones i was shipped were capable of transmitting any data. The arduino's that I tried them on showed signs of trying to transmit, but nothing ever went across. When I tried sending signals to one of these using another nRF24L01 (the ones WITHOUT an external antenna) it received data just fine and consistently, even between rooms. Does anyone have any ideas on what might be going wrong? Ive spend multiple nights going through google searching this and no one else seems to have this issue :/EDIT: I finally realized after a few days of testing (yes I'm embarrassed but willing to admit it) that I wasnt supplying enough power to the transceiver. If you plan on using this with an arduino, be sure to use something besides the on board 3.3v pin to power this. The 3.3v pin is fine for the nRF24L01's without the attachable antenna, but these need more consistent and stronger current to reliably transmit data